Rotary Hammer HR3520B HR3850B HR3850K DOUBLE INSULATION
SPECIFICATIONS Model HR3520B Capacities Tungsten-carbide bit ....................................................................... 35 mm Core bit ........................................................................................... 79 mm No load speed (min–1) ....................................................................... 440 Blows per min. ................................................................................... 3,300 Overall length ................................................
1 2 3 4 5 6 7 8 3
9 10 11 12 13 14 Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. [ Read instruction manual.
ENGLISH 1 2 3 4 5 6 7 8 Side grip Grip base Red dot (Tool holder) Red dot (Tool retainer) Tool retainer Press in Turn 180° Change lever Explanation of general view 9 10 11 12 13 14 15 16 For rotation with hammering For hammering only Wing bolt Depth gauge Switch trigger Core bit Adapter Center bit 17 18 19 20 21 22 23 24 Rod Hex wrench Rear cover Screwdriver Brush holder cap Lock nut wrench Crank cap Hammer grease 12. Secure work Use clamps or a vise to hold work.
Installing or removing drill bit or other bits (bull point, etc.) (Fig. 3 & 4) 22. Have your tool repaired by an expert This electric appliance is in accordance with the relevant safety rules. Repairing of electric appliances may be carried out only by experts otherwise it may cause considerable danger for the user. Important: Always be sure that the tool is switched off and unplugged before installing or removing the bit.
Hammer drilling operation MAINTENANCE Position the bit at the location for the hole, then pull the trigger. Do not force the tool. Light pressure gives best results. Keep the tool in position and prevent it from slipping away from the hole. Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove from the hole. By repeating this several times, the hole will be cleaned out.
Made in Japan 883660H1