ENGLISH (Original instructions) INSTRUCTION MANUAL Rotary Hammer HR2460 HR2460F 007932 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model HR2460/HR2460F Tungsten-carbide tipped bit 24 mm Core bit 54 mm Diamond core bit (dry type) 65 mm Concrete Capacities Steel 13 mm Wood 32 mm No load speed (min-1) 0 - 1,100 Blows per minute 0 - 4,500 Overall length 362 mm Net weight 2.8 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
Power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 19.
2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. FUNCTIONAL DESCRIPTION Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock.
Torque limiter Reversing switch action 1 B The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the output shaft. When this happens, the bit will stop turning. 1. Reversing switch lever A • • 007935 CAUTION: Always check the direction of rotation before operation. • Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.
Installing or removing the bit 2 1 The depth gauge is convenient for drilling holes of uniform depth. Loosen the side grip and insert the depth gauge into the hole in the side grip. Adjust the depth gauge to the desired depth and tighten the side grip. 1. Bit shank 2. Bit grease NOTE: • The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. Dust cup 003150 1. Dust cup Clean the bit shank and apply bit grease before installing the bit. 1 1. Bit 2.
NOTE: Eccentricity in the bit rotation may occur while operating the tool with no load. The tool automatically centers itself during operation. This does not affect the drilling precision. • Blow-out bulb (optional accessory) • 1. Blow-out bulb 1 • • 002449 After drilling the hole, use the blow-out bulb to clean the dust out of the hole. • Drilling in wood or metal 1. Chuck adapter 2.
• • • • • • • • • • • • • Drill chuck assembly Drill chuck S13 Chuck adapter Chuck key S13 Bit grease Side grip Depth gauge Blow-out bulb Dust cup Dust extractor attachment Safety goggles Plastic carrying case Keyless drill chuck 8
Makita Corporation 884705B8 12