ENGLISH (Original instructions) INSTRUCTION MANUAL Screwdriver FS2700 FS2701 010124 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH (Original instructions) SPECIFICATIONS Model FS2700 Self drilling screw Capacities FS2701 6 mm Machine screw 8 mm Wood screw 6.2 mm No load speed (min-1) 0 - 2,500 Overall length 301 mm Net weight 1.8 kg Safety class 283 mm 1.7 kg /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 19. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 20.
CAUTION: Do not look in the light or see the source of light directly. To turn on the lamp, pull the trigger. Release the trigger to turn it off. • 1mm NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 010119 Reversing switch action Switch action 1. Reversing switch lever 1. Switch trigger 2. Lock button 1 A B 1 2 010122 010121 CAUTION: Always check the direction of rotation before operation.
not suitable for the screw, continue adjusting until the proper torque is obtained. 1. Bit 2. Sleeve 1 • CAUTION: The adjusting ring should be turned only within the numbered range. It should not be forced beyond this range. 2 Hook 1 010128 1. Hook To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. NOTE: • If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured.
• rotate suddenly. This could damage a workpiece or cause an injury. Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may be damaged. MAINTENANCE CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Makita Corporation Anjo, Aichi, Japan 884918B227 8