ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Stapler BST220 BST221 009146 IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model BST220 Staple width 10 mm BST221 10 mm Applicable staples length 10 mm - 22 mm 10 mm - 22 mm Staple magazine capacity 84 pcs 84 pcs Overall length 247 mm 251 mm Net weight Rated voltage 2.3 kg 2.4 kg D.C. 14.4V D.C. 18V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country.
6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
rate for which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 19. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 20.
14. 15. 16. 17. 18. 19. (3) Do not tamper with the tool or attempt to use it for other than driving fasteners. Do not operate the tool without fasteners. It shortens the service life of the tool. Stop driving operations immediately if you notice something wrong or out of the ordinary with the tool. Never fastener into any materials which may allow the fastener to puncture and fly through as a projectile.
NOTE: • There is a possibility that the tool may operate for an instant when only the trigger is pulled. This does not indicate a problem. If this occurs, point the tool well away from yourself or any bystanders. Release and pull the trigger again to make sure the safety systems are in working order. FUNCTIONAL DESCRIPTION • CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Hook 1. Staples 2. Main magazine 1 2 • CAUTION: Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before using the hook. 1. Groove 2. Hook 3. Screw 1 009153 To secure the sub magazine in place, hook the locking lever on the rear of the sub-magazine. • CAUTION: With the magazine loaded, if the tool is held downward and the sub-magazine is opened, the staples can fall out and present a danger to anyone or anything below.
(1/4 turn) so that the groove on the nut runs parallel to the magazine. sight window to check if there are staples in the magazine. When staples are not visible through the window, load staples into the magazine. Driving staples Removing jammed staples 1. Front 2. Workpiece 3. Rear WARNING: Always make sure that the trigger are released and the battery cartridge is removed before removing jammed staples . Remove the battery cartridge from the stapler.
NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country.
Makita Corporation Anjo, Aichi, Japan 884841D226 12 www.makita.