ENGLISH: Original instructions INSTRUCTION MANUAL Cordless Lawn Mower DLM330 Read before use. Read before use.
SPECIFICATIONS Model: DLM330 Mowing width (blade diameter) 330 mm 4,300 min-1 No load speed Part number of replacement mower blade Dimensions (L x W x H) GB00000042 during operation L: 1,285 mm to 1,350 mm W: 375 mm H: 935 mm to 975 mm when stored (without grass basket) 520 mm x 375 mm x 775 mm Rated voltage D.C. 18 V Net weight 11.6 - 12.
Intended use SAFETY WARNINGS The machine is intended for lawn mowing. General power tool safety warnings Noise WARNING: Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The typical A-weighted noise level determined according to EN 60335-2-77, IEC 62841-4-3: Sound pressure level (LpA) : 82.4 dB(A) Sound power level (LWA) : 89.
2. 3. 4. 5. 6. 7. 8. 9. Use personal protective equipment. Always wear eye protection. Protective equipment such as a dust mask, non-skid safety shoes, hard hat or hearing protection used for appropriate conditions will reduce personal injuries. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool.
7. Follow all charging instructions and do not charge the battery pack or tool outside the temperature range specified in the instructions. Charging improperly or at temperatures outside the specified range may damage the battery and increase the risk of fire. 13. 14. Service 1. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 2. Never service damaged battery packs.
4. 5. Do not insert the lock key into mower until it is ready to be used. Always wear protective goggles to protect your eyes from injury when using power tools. The goggles must comply with ANSI Z87.1 in the USA, EN 166 in Europe, or AS/NZS 1336 in Australia/New Zealand. In Australia/New Zealand, it is legally required to wear a face shield to protect your face, too. 3. 4. 5. 6. 7. 8. 9. 10. 6. 7. 8. 9. 10.
23. 24. 25. 26. 27. 28. 29. 30. 31. If the mower strikes a foreign object, follow these steps: - Stop the mower, release the switch lever and wait until the blade comes to a complete stop. - Remove the lock key and the battery cartridge. - Thoroughly inspect the mower for any damage. - Replace the blade if it is damaged in any way. Repair any damage before restarting and continuing to operate the mower. Do not start the mower when standing in front of the discharge opening.
. 9. 10. 11. After removing the battery from the machine or charger, be sure to attach the battery cover to the battery and store it in a dry place. Do not replace the battery with wet hands. Avoid dangerous environment. Don't use the machine in dump or wet locations or expose it to rain. Water entering the machine will increase the risk of electric shock. If the battery cartridge gets wet, drain the water inside and then wipe it with a dry cloth.
Tips for maintaining maximum battery life 1. 2. 3. 4. 5. NOTE: Make sure that there is no gap between the lower handle and the mower body after the clamping levers are folded. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.
2. Hold the handle of the grass basket, and then hook the grass basket on the rod of the mower body as shown in the figure. Removing the mulching plug 1. Open the rear cover. 2 1 3 1 Fig.5 ► 1. Rear cover Fig.8 ► 1. Rod 2. Handle 3. Grass basket 2. Hold the mulching plug by the handle, and then pull it out from the mower body as shown in the figure. To remove the grass basket, open the rear cover, and then remove the grass basket by holding the handle. Attaching the mulching plug 1 1.
FUNCTIONAL DESCRIPTION 3. Insert the lock key in the place shown in the figure as far as it will go. Installing or removing battery cartridge 1 CAUTION: Always switch off the machine before installing or removing of the battery cartridge. CAUTION: Hold the machine and the battery cartridge firmly when installing or removing battery cartridge.
Protections against other causes Indicator lamps Protection system is also designed for other causes that could damage the machine and allows the machine to stop automatically. Take all the following steps to clear the causes, when the machine has been brought to a temporary halt or stop in operation. 1. Turn the machine off, and then turn it on again to restart. 2. Charge the battery(ies) or replace it/them with recharged battery(ies). 3. Let the machine and battery(ies) cool down.
2. Press the switch button and hold it. 3. Hold the upper handle and pull the switch lever. The table below shows the relationship between the number on the mower body and the approximate mowing height. 2 1 Fig.17 ► 1. Switch button 2. Switch lever Mowing height 1 20 mm 2 26 mm 3 33 mm 4 42 mm 5 52 mm 6 62 mm 7 71 mm 8 75 mm NOTE: The mowing height figures should be used just as a guideline.
Adjusting the handle height OPERATION WARNING: Do not touch rotating blade. Mowing CAUTION: Before removing the bolts, hold WARNING: Before mowing, clear away sticks and stones from mowing area. Furthermore, clear away any weeds from mowing area in advance. the upper handle firmly. Otherwise, the handle may fall and cause an injury. The handle height can be adjusted in three levels. WARNING: Always wear the safety goggles or safety glasses with side shields when operating the mower. 1.
The center lines of the front wheels are guidelines to mowing width. Using the center lines as guidelines, mow in strips. Overlap by one half to one third the previous strip to mow the lawn evenly. 1 2 3. Open the rear cover and take out the grass basket by holding the handle. 1 3 2 Fig.26 ► 1. Rear cover 2. Handle Fig.24 ► 1. Mowing width 2. Overlapping area 3. Center line 4. Change the mowing direction each time to prevent the grass grain pattern from forming in just one direction.
6. Store the grass basket between the handle and the mower body. Storage CAUTION: When putting the machine in the upright position, place the machine on a flat and stable surface. If the machine is placed on an unstable surface, the machine may fall over and cause an injury. 1 Store mower indoors in a cool, dry and locked place. Don't store the mower and charger in locations where the temperature may reach or exceed 40 °C. 1. Remove the battery cartridge and lock key. 2. Remove the grass basket. 3.
Removing the mower blade 4. Remove the bolt and blade in order. 1. Put the mower on its side so that the mowing height adjusting lever comes to the upper side. 2. To lock the blade rotation, insert a screwdriver or a similar tool into a hole on the mower body. 3. Turn the bolt counterclockwise with the wrench. 1 1 2 Fig.32 ► 1. Blade support 2. Mower blade 3. Bolt 3 Installing the mower blade To install the mower blade, take the removal procedure in reverse.
OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita machine specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Makita Europe N.V. Jan-Baptist Vinkstraat 2, 3070 Kortenberg, Belgium Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan www.makita.