ENGLISH (Original instructions) INSTRUCTION MANUAL Sharpener 9820-2 007269 IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model 9820-2 Wheel size 200 mm x 25 mm x 75 mm No load speed (RPM) Hz Overall length 50 460 60 560 360 mm Net weight 8.5 kg Safety class Class I • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. END224-1 For safe operations: Symbols 1. The following show the symbols used for the equipment.
11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. Do not abuse the cord. Never carry the tool by the cord or yank it to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges. Secure work. Use clamps or a vice to hold the work. It is safer than using your hand and it frees both hands to operate the tool. Do not overreach. Keep proper footing and balance at all times. Maintain tools with care. Keep cutting tools sharp and clean for better and safer performance.
To install the grinding wheel, follow the removal procedure in reverse. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Adjusting wheel guard The top of the wheel guard should be 1 mm below the surface of the grinding wheel.
Adjusting sharpening platform guide 3 4 1. Sharpening platform guide (Rail) 2. Blade/knife sharpening angle 3. Angle adjustment screw 1 2 3 007277 Fasten the pole fastening screws clockwise to fix the platform poles. Adjusting sharpening holder The sharpening holder horizontal (forward) adjust screws should be unscrewed to allow the heel of the blade to be inserted so as to contact the blade fastening screws. Then lightly tighten the blade fastening screws and set the holder on the platform.
1 4 2 Draining used coolant 1. Wheel 2. Left-hand fastening screw 3. Left-hand (forward) adjust screw 4. Planer blade The used coolant drains out through the drain hose (vinyl tube) provided. Have a pan or drain system ready to catch it. 1. Drain hose (Vinyl tube) 3 007280 1 Installing coolant reservoir (Tank) Insert the reservoir legs into the grooves provided for them on the sharpener frame. 007284 1. Coolant reservoir (Tank) 2.
Sharpening power planer blades Sharpen your planer blades to 40° angle. 1. Approx. 40 2. Planer blade 1 2 007288 • • CAUTION: Clean and dry the tool after operation. Be sure that the tool is switched off, unplugged and drained before attempting to move the tool. MAINTENANCE CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
Makita Corporation 883277B0 8 www.makita.