ENGLISH (Original instructions) INSTRUCTION MANUAL Sander Polisher 9207SPB 003427 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model 9207SPB Wool bonnet Max. capacities 180 mm Abrasive disc 180 mm Rated speed (n)/No load speed (n0) High: 3,800 min-1, Low: 2,000 min-1 Overall length 455 mm Net weight 3.4 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 19. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 20.
3. 4. 5. 6. 7. 8. 9. 10. accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and shock the operator. 11. Position the cord clear of the spinning accessory. If you lose control, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory. 12. Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. 13.
e) Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent kickback and loss of control Safety Warnings Specific for Sanding Operations: 17. Do not use excessively oversized sanding disc paper. Follow manufacturers recommendations, when selecting sanding paper. Larger sanding paper extending beyond the sanding pad presents a laceration hazard and may cause snagging, tearing of the disc or kickback.
ASSEMBLY • To remove the disc, follow the installation procedure in reverse. Installing or removing the wool bonnet CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 1 Installing side grip (auxiliary handle) 1. Side grip 1. Wool bonnet 2. Lock nut 3. Rubber pad 2 3 003461 Mount the rubber pad onto the spindle. Screw the lock nut onto the spindle.
Never run the tool without the abrasive disc. You may seriously damage the pad. Hold the tool firmly. Turn the tool on and then apply the abrasive disc to the workpiece. In general, keep the abrasive disc at an angle of about 15 degrees to the workpiece surface. Apply slight pressure only. Excessive pressure will result in poor performance and premature wear to abrasive disc. time. Use only identical carbon brushes. Use a screwdriver to remove the brush holder caps.
Makita Corporation 883892-923 8