ENGLISH (Original instructions) INSTRUCTION MANUAL Curved Planer 1002BA 002539 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model 1002BA Planing width 110 mm Planing depth 4 mm No load speed (min-1) 15,000 Overall length 339 mm Net weight 5.2 kg Safety class II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-5 Save all warnings and instructions for future reference.
accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 21. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 22. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation.
7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. Be sure the blade installation bolts are securely tightened before operation. Hold the tool firmly with both hands. Keep hands away from rotating parts. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced blade. Make sure the blade is not contacting the workpiece before the switch is turned on. Wait until the blade attains full speed before cutting.
For tool without lock button and lock-off button To start the tool, simply pull the switch trigger. Release the switch trigger to stop. For tool with lock button To start the tool, simply pull the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it.
1. Sharpening holder 2 1 1. Screwdriver 2. Chip cover 1 002588 002593 First, loosen the two wing nuts on the holder and insert the blades (A) and (B), so that they contact the sides (C) and (D). Then tighten the wing nuts. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 1 5 2 1. Brush holder cap 1. Wing nut 2. Blade (A) 3. Blade (B) 4. Side (D) 5.
Makita Corporation Anjo, Aichi, Japan 884054A3 8 www.makita.
