P.1 P.1 3OHDVH UHDG FDUHIXOO\ WKH DVVHPEO\ LQVWUXFWLRQV EHIRUH WKH LQVWDOODWLRQ 'R QRW GLVFDUG WKLV PDQXDO RU DQ\ RI WKH SDFNDJLQJ PDWHULDO XQWLO WKH XQLW KDV EHHQ FRPSOHWHO\ DVVHPEOHG 0LJKW UHTXLUH WZR SHRSOH
P.2 P.
P.3 P.
P.4 P.4 LIST OF SCREWS AND FITTINGS PART QTY. ITEM PART QTY.
P.5 P.5 BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS. ❶ Do a quick inventory to make sure the package contains all the parts and hardware listed in the assembly instructions. ❼ To avoid misalignments, always leave the screws loose and tighten them until all pieces are positioned correctly. ❷ Missing, damaged and defective parts can be replaced at no cost to you. Please refer to the CONTACT card included with the product.
P.6 P.
P.7 P.7 STEPS FOR ASSEMBLY STEP 3 Hardware: B 3x15mm x4 8 8 STEP 4 Hardware: B 3x15mm x8 Use screws (B) to assemble the flat drawer sliders (8) on the middle and bottom sets of slider holes as indicated. The wheels will be facing towards the front of the panels.
P.8 P.8 STEPS FOR ASSEMBLY STEP 5 Hardware: B 3x15mm 4 9 10 10 9 x6 4 4 4 IMPORTANT: Make sure you use in this step the correct sliders ( 4 ) which are longer and have more holes than sliders ( 22 ).
P.9 P.
P.10 P.
P.11 P.
P.12 P.
P.13 P.13 STEPS FOR ASSEMBLY STEP 20 28 Hardware: J 6X30mm x3 29 STEP 21 29 Hardware: H 6X35mm x3 STEP 22 Insert the Pins (M) into one of the 3 sets of holes on the CPU box side panels (16 & 18), and place the Auxiliary panel (17). Hardware: H M 6X35mm 17 x3 x4 3 3 Slide in the drawers starting with the bottom one, then top drawer. The top drawer might need to be inserted at an angle with its front facing down.
P.14 P.14 FINAL STEP ALL DONE! Give yourself a nice pat on the back.
P.15 P.15 AFTER THE ASSEMBLY IS DONE, PLEASE READ CAREFULLY THE FOLLOWING WARNINGS FOR CARE AND MAINTENANCE: • Do not exceed the indicated weight limits. • Do not expose the surfaces to direct sunlight or to extreme environmental conditions. • Clean the surfaces preferable with a clean cloth damped in a solution of mild soap and water, then dry with a clean towel. • Do not use solvents or abrasive materials to clean the unit.