tDynamo GenⅡ Model: 21079837 Manual December 2019 Version 001 Content 1 Installation Guide ……………………………………….............................2 2 Operation Guide ………………………………………………..................................3-8 3 Transactions Guide …………………………………………………………………….
1. Installation Guide 1.1 tDynamo Gen Ⅱ has two parts. 1.2 tDynamo Gen Ⅱ can be used alone, also can be used on the support .
2 Operation Guide There are three kinds of usage 2.1.1 First, press the button after using Bluetooth link equipment. 2.1.2 Second, on the card reader Connect the USB type - C interface, the other end is inserted into the host with USB interface, and then turn on power supply.
2.1.3 Third, put the reader into the base, with the base USB inserted into the host. Turn on power supply.
2.2 To use a MSR card Swipe card, make sure the MSR is on the bottom side, press the card to the bottom of the slot and swipe.
2.3 To use an IC card Make sure the IC contacts are on the top side. Insert the card to the end of the slot.
2.4 To use a NFC card Place the card near the NFC symbol on the case.
3 Transactions Guide Refer to the guide of the software. FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This product can be used across EU member states. We declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. RF Specification Bluetooth Operation Frequency: 2402〜2480MHz Maximum Power(V4.0): 5.34 dBm NFC Operation Frequency: Maximum Power: 13.56MHz 38.