User's Manual
IMPORTANT:
Please read this manual before using the unit to ensure safe and proper use.
The unit will generate the magne�c/electric field; never place any medical
equipment; watches; credit card; magne�c record card or any magne�c
sensi�ve products close to the unit.
Only phones with built-in QI wireless system can recharged by this unit. For
details, please refer the user’s manual of your phone.
The design of the unit is indoor use. Never spill or spray any type of liquid on the
product.
Do not use this product near water and moisture, for example: near a bathtub,
washbowl, kitchen sink or laundry tub; in a wet basement; or near a swimming
pool.
Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including ampliers) that produce heat.
Clean only with dry cloth. Unplug this product from external USB Charging
Devices before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dry
closth for cleaning.
Do NOT place any heavy object on the Charging Surface. It may damage the unit.
When replacement parts are required, be sure the service technician uses
replacement parts specied by the manufacturer or those that have the same
characteriscs as the original parts. Unauthorized substuons may result in re
or electric shock or other hazards.
1
FCC NOTICE:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against harmful
interference in a residenal installaon. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instrucons, may cause harmful interference to radio communicaons. However,
there is no guarantee that interference will not occur in a parcular installaon.
If this equipment does cause harmful interference to radio or television recepon,
which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or
modicaons to this equipment may cause harmful interference unless the
modicaons are expressly approved in the instrucon manual. Modicaons not
authorized by the manufacturer may void user’s authority to operate this device.
2
LOCATION OF CONTROLS:
1. Wireless Charging Surface
2. Micro USB Port
3. Blue & Green LED Indicator
3
3
2
1
OPERATION:
1. Connect the Micro USB Plug from the supplied USB connecon cable to the
Micro USB Port on the unit as illustrated below:
2. Connect the full size USB Plug to the USB Port on your USB Charger (not
included) as illustrated below:
3. The Blue & Green Indicators on the unit will illuminate & blink a few seconds, then
turn o.
4
4. Place your cell phone onto the center of the charging surface as illustrated
below unl the Blue and Green LED Indicator illuminate and blink slowly (or, the
charging icon appears on the cell phone’s display) to start charging.
(Note: If the loca�on of the cell phone is incorrect, charging will NOT proceed.)
5. Wait unl your cell phone nished charging as usual and full charging indicators
appear on your cell phone’s display
Notes:
1. To charge a cell phone with this Charger, the cell phone must be compable
with the Qi standard for wireless charging.
2. During charging, if the cell phone has a cover or case, it may disturb or prevent
the wireless charging funcon of the cell phone.
3. The charging transmission distance of the unit is less than 4mm, the thickness of
cell phone cover or case can NOT extend 4 mm.
4. To maximize the charging speed, using a USB Charger (not included) equipped
with Quick Charger 3.0 USB port.
5. Back of phone must be void of aachments or accessories to charge wirelessly.
6. To save energy, disconnect the Charger from the USB Charger if not using it for
an extended period of me.
5
GENERAL SPECIFICATION:
Input: DC 5V/2A or 9V/2A
Output: 5W or 10W
Transmission Distance: Up to 4 mm
ACCESSORIES:
1X Owner’s Manual
1X USB Connecon Cable (for charging only)
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE
6
3.5 in
4.75 in