WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY.
5
LOCATION OF CONTROLS 6
1. CD DOOR 14. (Next/Skip Forward) Button 2. LCD Display 15. ■ (Stop) Button 3. AL.SET (Alarm Set) Button (Play/Pause) 16. 4. TIME (Set) Button 17. TUNING Knob 5. POWER Indicator 18. HOUR (Set) Button 6. DBBS (Dynamic Bass Boost System) Indicator 19. DIMMER Button 7. Remote Receiver 20. AM/FM Button 8. AL. ON/OFF (Alarm On/Off) Button 21. POWER Button 9. TIME-DISP (Time Display) Button 22. MIN (Minute Set) Button 10. VOLUME Control Knob 23. MUSIC/BUZZER Button 11.
1. Battery Door 3 2 5 4 1 6 1. (Play/Pause) Button 2. (Next/Skip Forward) Button 3. (Previous/Skip Backward) Button 4. ■(Stop) Button 5. REPEAT Button 6.
CONNECTION: Connect the small plug from the Left and Right Speaker Boxes to the SPEAKER OUT L & R Jacks on the rear of main unit as the illustrated below: Right Speaker Box Left Speaker Box POWER SOURCE: Main Unit: Unwind the AC power cord and extend it to its full length.
Notes: This unit is equipped with a polarized AC plug which has one blade wider than the other. This is a safety feature to reduce the like holder of electric shock. This polarized AC plug will only fit in a polarized AC outlet. If you find that you cannot insert this plug into your outlet, you may have an obsolete non-polarized outlet. Please do not try to defeat this safety feature by using a non-polarized adaptor or by filling the wider blade to make it fit into your outlet.
REMOTE CONTROL: First time use: Remove and discard the insulation film as the illustrated follows: REMOVE BEFORE OPERATING Replacing the button cell when it is drained: Push and slide out the battery holder as the illustrated below. Replace the button cell with new CR2025 button cell as the polarity markings on the rear of the Remote Control. Close the battery holder. BATTERY PRECAUTIONS: Follow these Battery Precaution when using a battery in this device: 1.
possible battery leakage. 5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s instructions.) 6. Do not dispose of battery in fire. Battery may explodes or leak. 7. Clean the battery contacts and also those of the device prior to battery installation. 8. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burn in just 2 hours and can lead to death.
OPERATION GENERAL OPERATION: 1. 2. 3. 4. 5. 6. Connect the unit to AC power as previously instructed. The unit will enter to standby mode automatically and the LCD Display will illuminate. Press the POWER Button on the unit to turn on the unit from standby mode. The POWER Indicator will illuminate. Press the FUNCTION Button repeatedly to switch to desired playback mode.
ALARM SET: To set or reset the alarm time: In Standby mode, press and holding the AL. SET (Alarm Set) Button on the unit, alarm time will appear on the display and blinking. Then: Press the HOUR (Set)Button on the unit to set hour. (Make sure the PM Indicator appearing on the display if the alarm time is PM and AM Indicator appearing on the display if the alarm time is AM). Press the MIN (Minute Set) Button on the unit to set minute. When finished settings, release the AL.
BT (BLUETOOTH) : BT (Bluetooth) pairing First time use or re-pairing the unit to a new BT Device, pair as follows: 1. 2. 3. 4. Power on the unit and enter to BT mode as previously instructed. “bt” indicator will appear on the display and blink. Power on the external BT Device and enter to BT searching mode. Start pairing following the on screen instructions from the external BT Device. After paired, the “bt” indicator on the display will stop blinking.
Note: If stereo FM radio station is receiving in FM band. The FM stereo indicator “FM” will appear on the display automatically. Antennas: AM – This unit has a build in ferrite rod antenna, which provides adequate reception in most areas. If reception is weak, turn the unit to improve reception. FM – The FM Wire Antenna is for FM reception only. If reception is weak, unwound and relocation the wire antenna. CD: CD Playbacky: 1. 2. 3. 4. Open the CD door by press the CD OPEN (Close) area.
3. To cancel the repeat function, press the REPEAT Button repeatedly until all the repeat indicators disappear on the display. Programmed Playback: Up to 20 tracks can be programmed playback as follows: 1. 2. 3. 4. 5. 6. 7. In CD stop playing mode, press the PROG (Program) Button. “PROG 01” will appear on the display and PROG indicator will blink.
TROUBLESHOOTING Check the following before requesting service: SYMPTOM No power POSSIBLE CAUSE AC Power cord had not connected POSSIBLE SOLUTION Plug the AC Cord to any wall outlet having AC 120V~; 60Hz Volume of the unit was set to minimum Increase the volume level by No sound or sound weak position turning the VOLUME Control Knob clockwise Volume level of paired/connected Rise the volume level of the device is in low level paired/connected device Volume level too high Reduce the volume level b
SPECIFICATTIONS Power Source: Clock Back Up: BT Version: AC 120V~; 60Hz; 18W DC 3V; 2 x “AAA” size batteries (Not included) 5.0 BT Operation Distance: <=32 Feet in open area Radio Frequency: AM: 520-1710kHz FM: 87.
LIMITED WARRANTY Craig Electronics warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 180 days from date of purchase.