Owner's Manual

DC-5V
AUX
TF/USB
DC-5V
AUX
TF/USB
DC-5V
AUX
TF/USB
DC-5V
5.TF (Micro SD) Card Slot
7.AUX (Aux/Line in) Jack
SIZE: 70x158mm
FCC NOTICE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV
technician for help.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
FCC WARNING:
To assure continued operation, follow the attached
installation instructions and use only shield cables when
connecting to other devices. Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
1
1. Recharge the built-in Li-ion battery as previously
instructed.
2.
Press and hold the Button on the top of unit
approximately
1 second to power on the unit. The Blue
Indicator and control buttons on the top of unit will illuminate.
4. During playback:
● Press the Button to pause; press again to resume
to normal playback.
In AUX (Aux /Line in) mode, press it to mute the sound,
press again to turn the sound back on.
● Press and release the or buttons repeatedly to
adjust volume level as desired.
● Press and hold the or buttons repeatedly to skip
tracks.
Notes: It will not function in AUX (Aux /Line in) mode.
5. When finished listening, press and hold the Button
approximately 1 second to shut off the unit.
instructed. You will hear an audible prompt say “Bluetooth
ready for connection” and the Blue Indicator on the top
of unit will illuminate and blink.
2. Power on the external BT Device and enter to BT
search mode. Start pairing following the on screen
instructions from the external BT Device. When paired,
the unit will sound a prompt “Bluetooth connected” and
the Blue Indicator will stop blinking.
3. If pairing is complete you may now play music and
answer the phone with your external BT Device.
4. During playback：
● Press the Button on the unit to pause; press again
to resume to normal playback.
● Press and release the or buttons repeatedly to
adjust volume level as desired.
● Press and hold the or buttons repeatedly to skip
tracks.
5. If the unit is paired to a Cell Phone:
● When a call is incoming during an active music session:
Press the Button then speak into the Microphone to
answer the call. When your call is complete, press
the Button to disconnect or end the phone call and
resume to music playback.
Or, press and hold the Button approximately 1
second to decline the incoming phone call then
resume to music playback.
● Quick press the Button twice to redial the last
telephone number your cell phone called.
6. When finished listening, press and hold the Button
approximately 1 second to shut off the unit.
To listen from an external Audio Player such as MP3 Player,
Discman…etc.
1. In power off mode, connect one end of the supplied Audio
Connection Cable to the AUX Out / Line Out /Phone Jack
on the external Audio Player.
2. Open the Rubber Cover on the unit.
4. Power on the unit and enter to AUX mode as
previously instructed, you will hear an audible prompt
say “Aux in”.
5. Play the music on the connected Audio Player as usual.
(Make sure the volume level of the connected Audio
Player is turned to high level.)
6. During playback:
● Press the Button on the unit to mute the sound,
press again to turn the sound back on.
● Press and release the or buttons repeatedly to
adjust volume level as desired.
7. When finished listening, press and hold the Button
approximately 1 second to shut off the unit.
again to resume to normal playback.
● Press and release the or buttons repeatedly to
adjust volume level as desired.
● Press and hold the or buttons repeatedly to skip
tracks.
4. When finished listening, press and hold the Button
approximately 1 second to shut off the unit.
To play the music in TF (Micro SD) Card:
1. In power off mode, open the Rubber Cover on the unit
then insert the TF (Micro SD) Card (not included)
into the TF (Micro SD) Card Slot on the unit with contacts
facing down as illustrated below:
2. Power on the unit and enter to TF (Micro SD) Card mode
as previously instructed:
● You will hear an audible prompt say “Memory Card”.
● Music in the card will be played back automatically.
3. During playback:
● Press the Button on the unit to pause；press again
to resume to normal playback.
● Press and release the or buttons repeatedly to
adjust volume level as desired.
● Press and hold the or buttons repeatedly to skip
tracks.
4. When finished listening, press and hold the Button
approximately 1 second to shut off the unit.
Notes:
● U
p to 16 GB TF (Micro SD) Card/USB Device supported.
● When inserting the TF (Micro SD) Card/USB Device,
make sure the direction you selected is correct. Never
insert violently to avoid damaging the TF (Micro SD) Card/
USB Device or the unit. If it doesn’t work, please check
if the direction is correct.
● Before replacing TF (Micro SD) Card/USB Device, make
sure the unit has been powered off.
TROUBLESHOOTING:
Check the following before requesting service:
SPECIFICATIONS:
PACKAGE INCLUDES：
1 x Owner’s Manual
1 x USB Connection Cable (For Charging only)
1 x Audio Connection Cable with 3.5 mm Stereo Plugs
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT
TO CHANGE WITHOUT NOTICE
Voice Prompt:
Bluetooth ready for connection
Aux in
USB
Playback Modes:
BT (Bluetooth)
AUX ( Aux/Line in)
USB
Memory Card
TF (Micro SD) Card
Built-in DC 3.7 V, 1200 mAH (4.44 WH) rechargeable
Li-ion Battery; recharge by DC 5 V through Micro
USB Port
3 ohm
2 W per Channel (Total 4 W, RMS)
4.2
Up to 32 Feet in open area
Power Source
Impedance of Speakers
Audio Power
BT Version
BT Operation Distance
The unit has a built-in Li-ion rechargeable battery, charge it
before first time use or when it is drained as follows:
1. Open the Rubber Cover on the unit.
2. Connect the small plug from the supplied USB Connection
Cable to the Micro USB Port on the unit.
3. Connect the full size USB Plug from the supplied USB
Connection Cable to the USB Port on the Personal
Computer or USB Charger (Computer and USB Charger
not included).
4. When charging, the Red Charging Indicator on the top of
unit will illuminate.
5. When charging is complete, the Red Charging Indicator
will turn off.
6. Close the Rubber Cover completely to reduce water and
dusts entering.
To AUX Out/Line Out/
Phone Jack on the
external Audio Player
To AUX (Aux/
Line in) Jack
POSSIBLE SOLUTION
R
echarge the battery as page 2-3
Press and hold the Button
approximately 1 second to power
on the unit
Increase the volume level by
press and release the Button
repeatedly
Rise the volume level of the
paired/connected device
Reduce the volume level by
press and release the Button
repeatedly
Reduce the volume level of the
paired/connected device
Pair the external BT device to the
unit as page 4-5
Place the external BT device
close to the unit
POSSIBLE CAUSE
Built-in battery drained
The unit is in power off
mode
Volume of the unit was set
to minimum position
Volume level of
paired/connected device
is in low level
Volume level too high
Volume level of the
paired/connected device
too high
The external BT device
had NOT paired to the unit
The external BT device
too far from the unit
SYMPTOM
Can’t power on
No sound or
sound weak
Sound
distortion
BT not
functioning
1. Button
2. (Power On/Off & Mode Selection) Button
3.Indicators
4.Micro USB Port (For charging only）
6.USB Port
8.Microphone
9. Button
LOCATION OF CONTROLS
2
3
3. Connect the other end of the cable to the AUX ( Aux/
Line in) Jack as illustrated below:
Notes:
● When the external BT Device searches for the unit, our
model number “MMA3762” will appear on the display of
external BT Device.
● If while pairing you are asked for a code, please try "0000"
or "1234".
Normal operation after pairing:
1. Power on the external BT Device and enter to BT
playback mode.
4 5
6
10. Button
11.Rubber Cover (This cover is to ensure water and dusts
protection; always make sure it is completely closed.)
7
To Computer
or USB Charger
To Micro USB Port
3. Press the Button repeatedly to switch to desired
playback mode. The unit will sound a prompt with your
selection (see list below):
A. Before first time use, recharge the unit approximately 4
hours until the unit is fully charged.
B. Charge and store the unit within the temperature range
of
POWER SOURCE
Notes:
1. When charging, you can also play and listen to music at
the same time.
2. Your battery will last longer if you following these simple
guidelines for caring and storing:
5°C - 35°C (40°F - 95°F).
C. Do not overcharge (longer than 24 hours). Excessive
charging or running the unit until completely flat will
damage battery. Battery life will be extended if you keep
the battery fully charged.
D. Battery life naturally shortens slowly over time.
E. The rechargeable battery incorporated in this product is
not user replaceable.
General Operation:
Note:
If the Audio Connection Cable; TF (Micro SD) Card and/or
USB Device have NOT been inserted into the unit, the
corresponding selection will not be available.
1. Power on the unit and enter to BT mode as previously
3. During playback:
● Press the Button on the unit to pause；press
BT Mode:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair
as follows:
USB:
To play music in a USB Device:
1. In power off mode, open the Rubber Cover on the unit
then connect the USB Device (not included) into the
USB Port on the unit as illustrated below:
Line In ( Aux/Line in):
4. After pairing is complete you may now play music and
answer calls with your external BT Device.
Craig Electronics Inc. warrants this product to be free from
manufacturing defects in material and workmanship under
normal use for a period of 180 days from date of purchase. If
service is required, please return the product to the store where it
was purchased for exchange; or, pack the unit in the original
packing material with all accessories if applicable, a copy of your
sales receipt and a Cashier’s check or Money Order for $7 (to
cover shipping and handling costs) payable to Craig Electronics
Inc. For consumers in Canada, please make sure that the cashier
check or money order is redeemable through a U.S. bank. Ship
your product freight pre-paid. Your unit will be repaired, replaced
or if the unit can not be repaired or replaced, a refund will be
forwarded to you within four weeks of receipt of your unit. Please
ship your unit to:
Craig Electronics Inc.
1160 NW 163 Drive
Miami, Fl 33169
This warranty is void if the product has been: a) Used in a
commercial application or rental. b) Damaged through misuse,
negligence, or abuse. c) Modified or repaired by anyone other
than an authorized Craig service center. d) Damaged because it
is improperly connected to any other equipment.
Note: This warranty does not cover: a) Ordinary adjustments as
outlined in the Owner’s Manual which can be performed by the
customer. b) Damage to equipment not properly connected to the
product. c) Any cost incurred in shipping the product for repair. d)
Damage to the product not used in the USA.
This warranty is not transferable and only applies to the original
purchase. Any implied warranties, including the warranty of
merchantability, are limited in duration to the period of this
expressed warranty and no warranty whether expressed or
implied shall apply to the product thereafter.
Under no circumstance shall Craig Electronics Inc. be liable for
any loss or consequential damage arising out of the use of this
product. This warranty gives specific legal rights. However, you
may have other rights which may vary from state to state. Some
states do not allow limitations on implied warranties or exclusion
of consequential damage. Therefore, these restrictions may not
apply to you.
This product has been manufactured by and is sold under the
responsibility of Craig Electronics Inc, and Craig Electronics Inc.
is the warrantor in relation to this product. MAGNAVOX and
SMART. VERY SMART are registered trademarks of Koninklijke
Philips N.V. and are used under license from Koninklijke Philips
N.V.
To Obtain Service on your Product
email:[e-mail]
Printed in China MMA3762_WC_E0FK1_B0US
LIMITED WARRANTY
3. Wait a few seconds until the unit is automatically paired
to the external BT Device. The unit will sound a prompt
“Bluetooth connected” and the Blue Indicator will stop
blinking.
2. Power on the unit and enter to BT mode as previously
instructed. You will hear an audible prompt say “Bluetooth
ready for connection” and the Blue Indicator on the top of
unit will illuminate and blink.
2. Power on the unit and enter to USB mode as previously
instructed:
● You will hear an audible prompt say “USB”.
●
Music in the USB Device will be played back.
● You also need to download the desired music in MP3
format into the TF (Micro SD) Card/USB Device before
insert into the unit.
TF (Micro SD) Card:
AUX
DC-5V
TF/USB
AUX
TF/USB