AT449150 Operation and Installation Manual AM/FM CLOCK AUX/BT ALARM MUTE + + VOL TUNER - 1 2 MENU 3 4
Introduction Please take the time to read all of the information in this manual. Familiarity with operation and installation procedures will help you obtain the best possible performance from your new Entertainment Center. Index Button Locations and Functions ..................................................... General Operation ................................................................ Sound Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Button Locations and Functions 11 8 AM/FM AUX/BT 9 2 3 CLOCK ALARM 1 MUTE 7 + + VOL TUNER - 1 4 2 MENU 3 4 12 5 13 14 1. Power/Mute Button ( MUTE): Power: Press to turn the unit on when the unit is off, press and hold the button to turn the unit off. Mute:When the unit is on press and release this button to mute the audio, press again to restore the audio. 2. CLOCK Button: Press to switch between infor mation display and clock. hold the button clock adjust setup 3.
General Operations Power On: Press the / mute button to turn the entertain ment center on. AM/FM CLOCK AUX/BT Power Off: ALARM MUTE Press and hold the / Mute button for 2 sec onds to turn the unit off. + + VOL TUNER - - Mute: 2 1 When the unit is on press and release this button to mute the audio, press again to restore the audio. 3 MENU 4 Display Sound Controls Volume: + Increase the volume by pressing the VOL button. Decrease the volume by pressing the VOL button.
Sound Controls (Continued) Fader: Select the Fader mode by pressing the MENU button until “FAD F_R” appears in the display. Adjust the Fader to the front speakers by pressing the VOL+ button. Adjust the Fader to the Rear speakers by pressing the VOL- button. F- R = Equal sound Front and Rear. F 10F = Front speakers only. R 10R = Rear speakers only. Equalizer (EQ): Select the Equalizer mode by pressing the MENU button until “DSP OFF” appears in the display.
Bluetooth Operation Pairing Bluetooth Devices: 1. Open the Bluetooth setup program on the mobiledevice and activate the Bluetooth feature. 2. Press the button to turn on the entertainment AM/FM AUX/BT CLOCK ALARM center. MUTE + + 3. From you mobile device scan for available devices. VOL TUNER Select ”AT JD ” to connect to the unit. 4. When the mobile device has been paired “ ” will appear in the entertainment center’s display . 3 2 1 MENU 4 5. Press the BT/AUX button until “BT AUDIO” appears in the display.
Radio Operations Tuning in a Radio Station Using Seek: Press the TUNER+ button and the tuner will seek up to the next strong station and stop seeking, then start playing. Press the TUNER- button and the tuner will seek down to the next strong station and stop seeking, then start playing. Higher AM/FM CLOCK AUX/BT ALARM MUTE + + VOL TUNER - 2 1 MENU 3 4 Lower Manually Tuning in a Radio Station: Press and hold the TUNER+ button until “MANUAL” appears in the display.
ALARM Reception Operation: Setting the ALARM : 1:Hold press MENU button until display ALARM OFF, than press VOL (+/-) to open ALARM ON. LCD on display“ ALARM” 2: press ALARM button to display time, 3: hold press ALARM button again, when ARLAM blink, adjustment hour VOL (+) and minute VOL (-) to setting correct time. After complete the adjustment, wait for 8 sec to automatically set the time or press any button to finish time setting.
Speaker Connections White/Black Wire Gray/Black Wire White Wire Gray Wire Speaker Connections Left Front Speaker Right Front Speaker Wiring Harness 10 Amp Fuse Model: SPA-HAR (Sold Separately) Gray Wires Audio Out Right External Automotive Type Antenna (Optional) Left Left Rear Speaker Red Wire (+) to 12 Volt Ignition Black Wire Ground Blue WireTrigger for Amp (+12VDC) Green/Black Wire Violet/Black Wire Green Wire Violet Wire Right Rear Speaker
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.