CT-14 CT-14 1x4 Digital Audio Coaxial S/PDIF Thru Box MANUAL ™
CT-14 TM 1x4 Digital Audio Coaxial S/PDIF Thru Box Thank you for purchasing the CT-14, by M Audio. The CT14 accepts one S/PDIF digital audio signal via coaxial RCA connector and duplicates it to four S/PDIF coaxial RCA outputs, all on the rear of the CT-14. This allows you to take the S/PDIF output of any digital audio source, such as a DAT, CD player, digital mixer, etc., and send it simultaneously to four digital audio targets that are capable of receiving S/PDIF format signals.
CT-14 Hook-Up Diagram 1. 2. 3. 4. 5. 6. With the CT-14 power button in the “out” (off) position, plug the appropriate end of the supplied 9-Volt DC “wall-wart” power adapter into your CT-14 and the other end into a wall socket or power strip. The CT-14 power indicator LED should be off. Take the output of your digital audio source device and plug it into the CT-14 coaxial RCA input connector located on the rear of the CT-14 .
NOTE: When any signal is present at the CT-14 input, the “Signal Present” LED will light on the front of the unit. The CT-14 is “format neutral” and does not analyze the incoming signal. Therefore, although signal presence is detected by the CT-14, it may not necessarily be a valid S/PDIF format signal. Other Typical uses of the CT-14 • • • • Sending a single digital out to multiple digital effects units. Outputting to several D/A converters simultaneously.