MAKE THE MOST OF YOUR LN24BF OUTDOOR REFRIGERATOR/BEVERAGE DISPENSER CARE & USE/INSTALLATION
CONTENTS Contents Important Safety Instructions Safety information ...............................................................2 Unpacking your appliance ..................................................3 Warranty registration .....................................................3 Installing your appliance ......................................................4 Cabinet clearances .........................................................4 Leveling the appliance .........................................
UNPACKING YOUR APPLIANCE ! WARNING EXCESSIVE WEIGHT HAZARD Use two or more people to move product. Failure to do so can result in personal injury. Remove Interior Packaging Your appliance has been packed for shipment with all parts that could be damaged by movement securely fastened. Remove internal packing materials and any tape holding internal components in place. The owners manual is shipped inside the product in a plastic bag along with the warranty registration card, and other accessory items.
INSTALLING YOUR APPLIANCE Select Location Front Grille, keep this area open. The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to specifications, the recommended installation location temperature range is from 50 to 100°F (10 to 38°C). Cabinet Clearance Ventilation is required from the bottom front of the appliance.
INSTALLING YOUR APPLIANCE Do not remove ground prong ! WARNING Electrical Shock Hazard • Do not use an extension cord with this appliance. They can be hazardous and can degrade product performance. • This appliance should not, under any circumstances, be installed to an un-grounded electrical supply. • Do not remove the grounding prong from the power cord. (See Figure 3). • Do not use an adapter. (See Figure 4). • Do not splash or spray water from a hose on the appliance.
PRODUCT DIMENSIONS ROUGH-IN OPENING DIMENSIONS MODEL "A" "B" LN24BF 24" (61 cm) **34" to 35" (86.4 to 88.9 cm) CABINET DIMENSIONS "C" "D" "E" "F" "G" "H" "J" * 237⁄8" (60.7 cm) 333⁄4" to 343⁄4" (85.7 to 88.3 cm) 2323⁄32" (60.2 cm) 263⁄4" (67.9 cm) 4613⁄32" (117.9 cm) 263⁄4" (67.
PRODUCT DIMENSIONS PRODUCT DATA MODEL ELECTRICAL REQUIREMENTS# PRODUCT WEIGHT LN24BF 115V/60Hz/15A 140 lbs (63.6 kg) "J" "H" "G" "D" "E" Figure 9 211⁄2" (54.6 cm) "F" * Depth dimension of rough-in opening may vary depending on each individual installation. To recess entire door "F" dimension plus 1" (2.5 cm) for thickness of power cord plug is required. ** Minimum rough-in opening required is to be larger than the adjusted height of the cabinet.
USING YOUR ELECTRONIC CONTROL Figure 13 Electronic control Control Function Guide Function Command Notes ON/OFF Press Unit will immediately turn ON or OFF. Leave Interior Light On Press and release to leave interior light on for 3 hours; press again to deactivate. After 12 hours, factory default is restored; light will turn on when door is open. Adjust Temperature Press or and release. When the display is flashing, press or to adjust the set point temperature.
USING YOUR BEVERAGE DISPENSER Shelving The unit is shipped with the (2) shelves taped in place in the upper and the lower shelf positions. Remove them from the refrigerator and arrange them as follows when setting up your unit. If you are using a quarter barrel of beer or wine, you can add shelf space for keeping your mugs chilled. The quarter barrel must set on the floor, it cannot fit on the shelf, see Figure 14.
USING YOUR BEVERAGE DISPENSER This beverage dispensing unit will support one half (1⁄2) barrel or one quarter (1⁄4) barrel. The double draft tower units can support two sixth (1⁄6) barrels of beverage. See chart below for quantity of beverage in each barrel size. Barrel Sizes 1/6 barrel 1/4 Barrel 1/2 Barrel Height 5 23 ⁄16" (59.2 cm) 14 ⁄16" (37.6 cm) 235⁄16" (59.2 cm) Diameter 91⁄4" (23.5 cm) 17" (43.2 cm) (43.2 to 43 cm) Gallons 5.16 7.75 15.
USING YOUR BEVERAGE DISPENSER Single Dispense Tower Kit A Connect A to Double Dispense Tower Kit ,etc........ Connect A to A ,etc........
USING YOUR BEVERAGE DISPENSER Rear of counter top 13⁄8" (3.5 cm) typical Diameter to suit counter top depth 255⁄16" (64.3 cm) 11⁄2 (38 mm) Diameter 27⁄8" (7.3 cm) 1 ⁄4" (6 mm) radii, typical 41⁄4" (10.8 cm) 61⁄8" (15.6 cm) 63⁄8" (16.2 cm) 121⁄4" (31.1 cm) Figure 27 ! CAUTION The cutout dimensions shown in Figure 27 are based on a 255⁄16" (64.3 cm) deep counter top. Your counter top may be different than this and require other front to back dimensioning.
USING YOUR BEVERAGE DISPENSER the faucet handle on the tower. 9. Hooking up the keg coupler to the keg: Verify the coupler is in the "OFF" position (see Figure 31a).Align the lugs on the keg with the corresponding openings on the keg coupler and turn clockwise until the coupler stops (about 90°). Push down and twist the top of the coupler clockwise to allow gas to enter the keg.
USING YOUR BEVERAGE DISPENSER Gas Regulator (Single Dispense Tower) Gas Regulator (Double Dispense Tower) Your beverage dispenser comes equipped with a 5 pound gas tank and a single gauge regulator. The gauge reads the pressure being supplied to the beverage keg. Follow the procedure below to adjust the pressure: 12-14 psi for lager beer 9-12 psi for ale's 3-8 psi for still wines 20-40 psi for sparkling wines Your beverage dispenser comes equipped with a 5 pound gas tank and a dual gauge regulator.
USING YOUR BEVERAGE DISPENSER AND CARE AND CLEANING Drain kit (All Models): The drain kit is shipped in place and ready to use. To empty: Pull drain hose out of bottle cap, remove bottle from unit, unscrew cap and discard waste and rinse bottle. Reinstall bottle in unit.
CARE AND CLEANING Cleaning and Maintaining Dispensing System Faucet Cleaning The dispensing system needs to be cleaned between usage to prevent spoilage and/or foul taste in your beer or wine. Turn off the gas supply with the shutoff valve(s) under the regulator (see Figure 33 or Figure 34) and open the faucet to relieve the pressure. To remove the faucet from the tower use the spanner wrench provided.
CARE AND CLEANING Tap Cleaning Kit Front Grille This is an optional item (part number 42242373) Kit includes everything to quickly clean tap. Includes cleaning solution, pump, mixing bottle, brush and wrench. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the front grille area (see page 4).
CARE AND CLEANING Long Term Storage/Winterization Time to Winterize, when the daily low ambient temperature is at or below 38° F. ! CAUTION Operating of the unit at ambient temperatures below the recommended Winterization temperature will void your warranty. Front grille Figure 42 1. Turn unit off, (see page 8). 2. Remove all contents. 3. If necessary, move the unit so you can gain access to the rear of the product. 4. Unplug the unit from the power outlet. 5.
CARE AND CLEANING 17. Thoroughly clean the door gasket with anti-bacterial cleaner to be followed with clean rinse water to remove any residual chemicals. 18. Thoroughly clean the exterior with a cleaner approved for stainless steel . Do not use any abrasive cleaners or scouring pads. 19. Any mounting hardware / fasteners that are showing signs of corrosion should be replaced. 20.
STAINLESS STEEL MAINTENANCE AND ENERGY SAVING TIPS Background Stainless steel does not stain, corrode, or rust as easily as ordinary steel, but it is not stain or corrosion proof. Stainless steels can discolor or corrode if not maintained properly. Stainless steels differ from ordinary carbon steels by the amount of chromium present. It is this chromium that provides an invisible protective film on the surface called chrome-oxide.
OBTAINING SERVICE If Service is Required: • • • • • If the product is within the first year warranty period please contact your dealer or call Lynx Grills Customer Service at 888-289-5969 for directions on how to obtain warranty coverage in your area. In all correspondence regarding service, be sure to give the service/model number, serial number, and proof of purchase.
TROUBLESHOOTING Before You Call for Service If the appliance appears to be malfunctioning, read through this manual first. If the problem persists, check the troubleshooting guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. However, it may be required to contact your dealer or a qualified service technician.
HOUSEHOLD PRODUCT WARRANTY UNDERCOUNTER REFRIGERATOR / BEVERAGE CENTER WARRANTY TWO YEAR FULL WARRANTY Undercounter refrigerators / Beverage Centers and all of their component parts, except as detailed below*†, are warranted to be free from defective materials or workmanship in normal residential use for a period of two (2) years from the date of original retail purchase. Lynx, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.
The best outdoor kitchen products come from: Lynx Grills 62201 Highway 82 West Greenwood, MS 38930 Service: (888)-289-5969 www.lynxgrills.com 41016164 Rev A 6/21/21 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.