Lyngsoe Systems RFID Rd/Ex XR30 RFID Rx/Ex XR30 User Guide Revision - – August 07, 2009 950213-.
Lyngsoe Systems RFID Rd/Ex XR30 1. General RFID Rd/Ex XR30 is basically an RFID Exciter EX30 which incorporates also a Reader RD23. It can operate as an RFID Exciter and Reader to excite RFID Tags and to receive their UHF messages. RFID Rd/Ex XR30 as a combined unit provides all the functionalities documented for the EX30 and RD23 units. These functionalities and technical specifications are completely described by the following documents: - RFID Exciter EX30 User Guide - doc 950212-.
Lyngsoe Systems RFID Rd/Ex XR30 receptacle body – terminals 1 for (+24V), terminal 3 for (GND) voltage and terminal 2 (middle) for the ground. Remove the cover. Plug in the power connector into any of the corresponding headers on the RDS230. The POWER LED (green) goes ON. Exciter Board EXB30 Power connector RS485 connectors for master/slave RS485 connectors for network control 24Vdc power to other Exciters Reader Assy. RDS23 Ext 24V Power Fig 2-2 Connectors location for XR30 950213-.
Lyngsoe Systems RFID Rd/Ex XR30 Cover RS485 Cable Power Cable Fig 2-3 Cover installation for XR30 RS485 Connections For the RS485 connection use a standard Cat5 Ethernet cable and RJ45 plug. Crimp the connector using the recommended tool and the following color scheme: pin 1 - Wh/Or; pin 2 – Or; pin 3 – Wh/Gr; pin 4 – Bl; pin 5 – Wh/Bl; pin 6 – Gr; pin 7 – Wh /Br; pin 8 – Br. Insert the RS485 connector as in Fig.2-2. Close the cover as in Fig. 2-3. 2.2.
Lyngsoe Systems RFID Rd/Ex XR30 serial communication program like Procomm, through a serial communication link type RS485. There are several specific commands to configure or to query the XR30 parameters values. XR30 has a unique address called NetId. The NetId is an integer in the range 0 to 127 and is a good practice to clearly mark it on the front label in the designated area.
