User's Manual

REGULATORY COMPLIANCE AND SAFETY NOTIFICATION
This documentation contains regulatory compliance and safety information for both wireless and non-wireless hardware. Not all the information contained in
this document applies to every product.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
Regulatory Compliance
The device complies with internationally recognized standards covering human exposure to electromagnetic elds from radio devices. This equipment also
complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 24cm (9.4 in) during normal operation.
Unauthorized antennas, modications, or attachments could cause damage and may violate regulatory approvals. Any changes or modications not
expressly approved by the party responsible for compliance could void the authority to operate the equipment.
Luxul equipment marketed in the U.S. is restricted to usage of channels 1-11 only for 2.4GHz and channels 36-48/149-165 for 5GHz.
FCC Statement—Wireless FCC 2.4GHz & 5GHz 802.11b/g/n/ac
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with part 15 of the FCC Rules.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrol led environment. This equipment should be installed and operated with
minimum distance 24cm (9.4in) between the radiator & your body.

Summary of content (3 pages)