Installation & Assembly
www.allstarlighting.com
WARNING - RISK OF FIRE OR ELECTRIC SHOCK
INSTALLATION GUIDE
LR24870, LR24871, LR24872, LR24873, LR24874, LR24875, LR24876, LR24877, LR24878, LR24879
33 Randolph Ave. • Avenel NJ 07001 | 732-882-1500
1
4” DOWNLIGHT RETROFIT ROUND
• DO NOT MAKE OR ALTER ANY OPEN HOLES IN THE ENCLOSURE TO THE WIRING OR ELECTRICAL COMPONENTS DURING KIT INSTALLATION.
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR OTHER SHARP OBJECTS.
• SUITABLE FOR WET LOCATIONS
• SUITABLE FOR TYPE IC OR SUITABLE FOR TYPE NON-IC
• USE ONLY IN OPEN LUMINAIRES
• THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS
ASSEMBLY AND INSTALLATION
DIMMING: Dimming performance may depend on the dimmer, the dimmer range adjustment setting (for dimmers with brightness range adjustments), the wiring method, and/or the number of LED
modules installed onto the dimmer circuit. For dimmer selection, Dimming control manufacturers revise their product often; for the latest list of compatible dimmers please visit:
www.allstarlighting,com
For best results, it is recommended to install a minimum of four LED modules onto one dimmer. Before turning on the LED lights, set dimmer position at maximum before adjusting to a lower light
level. Please follow the dimming control manufacturer’s instructions for the installation of all dimming controls.
PLEASE READ CAREFULLY AND SAVE THESE INSTRUCTIONS, AS YOU MAY NEED THEM AT A LATER DATE.
DISCONNECT MAIN POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING THE FIXTURE.
GENERAL: ALL ELECTRICAL CONNECTIONS MUST BE IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODE (N.E.C.) STANDARDS. IF YOU ARE UNFAMILIAR
WITH PROPER ELECTRICAL WIRING CONNECTIONS OBTAIN THE SERVICES OF A QUALIFIED ELECTRICIAN,
• Thread the SOCKET ADAPTER into the SOCKET.
4”
Compatible Housing Can
E26
ADAPTER
CONNECTOR
• Tuck all wires into the CAN and carefully push the RETROFIT TRIM
into CAN. (NOTE: To provide enough room in shallow cans, carefully
position SOCKET ADAPTER and SOCKET adjacent to the long side of
the LED DRIVER prior to inserting the RETROFIT TRIM into the CAN.)
• Plug the FEMALE CONNECTOR of the RETROFIT
TRIM onto the MALE CONNECTOR of the HALO
HOUSING.
FIG. 1 FIG. 2
FIG. 4 FIG. 5
FIG. 3
ALUMINIUM
TABS