Full Product Manual

Product Name:
Patina Resin Rectangular Bubbler Outdoor Fountain with LED Lights and Bronze Birds
SKU #:
WHF485
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Quantity
Fountain Top
1
Fountain Base
1
Birds
7
Pump 1
Compatible Pumps for this fountain:
Pump Model No.
JR450/LED
JB450/LED
YH707/LED
YH-LV110T
Tools required for assembly: No tools required.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. From the opening at the top of the base fountain, lead the pump power cord out through the cord slot from
the top of the fountain to the base.
4. Place the pump inside the fountain. Insert the water supply tube from the underside of the fountain top into
the pump outlet. Insert the LED connector into the pump connector, and twist to tighten.
5. Please the top of the fountain securely on the base. Place birds into slots on top of the fountain.
6. Make sure the water tube is properly connected with the pump and is not crimped.
7. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin.
8. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
9. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
10. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.