LunaSafe TM Safety Products LL64 INSTRUCTIONS 1-800-272-0170 www.lunasea.
Transmitter Transmitter Functions Transmitter is a wearable device that has a approx 5 year battery built in. When tranmitter comes in contact with water it will send a signal to the receiver alarm which will sound audible and visual alarm. Locking Wrist Strap After threading the nylon strap through safety device and back through the locking connector, turn locking button 90 degrees as shown using a coin or screwdriver.
Receiver/Alarm Internal Antenna On/Off Button Pair/Reset Button Emergency Strobe Light Ready Indicator Receive Indicator Pairing Indicator Low Battery Indicator Audioable Alarm Test Indicator Charge Indicator Wireless Charge Area
Charging Receiver Make sure the unit is fully charged by placing it standing up on a charge pad. Then wait until Charging Light goes off. Turn Receiver On Momentarily press On/Off Button to turn on. Unit initializes and then Ready indicator blinks showing unit is in normal operation. Low Battery When battery becomes low the Low Bat Indicator will Blink. Place unit on Charge Pad until battery is fully charged. Charging light will then go off indicating full charge.
Pairing Receiver with Transmitter Press and hold the Check Button for 5 seconds then with wet fingers, wet cloth or dipped in water across both gold pins. You will see Pairing indicator blink multiple times showing the the device has been paired. You can do this with up to 16 tranmitters. To delete all pairing information, press and hold the Check Button for 10 seconds. This will erase all pairing memory. You may now pair new units to the receiver.
Alarm in Progress When Transmitter comes in contact with water the Strobe Light on the Receiver activates and a Lound Alarm activates. As soon as gold pins are dry the device stops transmitting, however the Receiver Alarm will continue to sound alarm. To reset the Receiver, press the Pair/Reset Button or the On/Off Button. If On/Off Button is pressed the unit will be in off state and will no longer monitor. LL63 Instructions Rev 3 www.lunasea.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
IC WARNING This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.