Users Manual Part 2

ManualsBrandsLunasea Lighting ManualsElectronicsLunaSafe

Unlocked Position

Locked Position

After threading the nylon strap through safety device and

back through the locking connector, turn locking button 90

degrees as shown using a coin or screwdriver.

Locking Wrist Strap

Place safety device on wireless charge pad so it is in the

center. You will see a green light show through the graphic

indicating that the unit is charging.

Most wireless charge pads

have LED indicators showing

when charging is taking place.

Charging Transmitter

Summary of content (7 pages)

PAGE 1
Charging Transmitter Place safety device on wireless charge pad so it is in the center. You will see a green light show through the graphic indicating that the unit is charging. Most wireless charge pads have LED indicators showing when charging is taking place. Locking Wrist Strap After threading the nylon strap through safety device and back through the locking connector, turn locking button 90 degrees as shown using a coin or screwdriver.
PAGE 2
Receiver/Alarm Internal Antenna On/Off Button Pair/Reset Button Emergency Strobe Light Ready Indicator Receive Indicator Pairing Indicator Low Battery Indicator Audioable Alarm Test Indicator Charge Indicator Wireless Charge Area
PAGE 3
Charging Receiver Make sure the unit is fully charged by placing it standing up on a charge pad. Then wait until Charging Light goes off. Turn Receiver On Momentarily press On/Off Button to turn on. Unit initializes and then Ready indicator blinks showing unit is in normal operation. Low Battery When battery becomes low the Low Bat Indicator will Blink. Place unit on Charge Pad until battery is fully charged. Charging light will then go off indicating full charge.
PAGE 4
Pairing Receiver with Transmitter Press and hold the Check Button for 5 seconds then simply press the Manual-On button on the tranmitter. You will see Pairing indicator blink multiple times showing the the device has been paired. You can do this with up to 8 tranmitters. To delete all pairing information, press and hold the Check Button for 10 seconds. This will erase all pairing memory. You may now pair new units to the receiver.
PAGE 5
Alarm in Progress When Transmitter is placed in water the Strobe Light on the Transmitter activates, the Strobe Light on the Receiver activates and a Lound Alarm on the Receiver activates. To reset the Strobe on the Transmitter simply push the Manual-On Button. Transmitter will need to be dry to reset. To reset the Receiver, press the Pair/Reset Button or the On/Off Button. If On/Off Button is pressed the unit will not be in off state and will no longer monitor. LL63 Instructions Rev 3 www.lunasea.
PAGE 6
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 7
IC WARNING This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.