Instructions / Assembly

INSTALLATION
1.SPREAD THE ARMS EVENLY.
2.INSTALL THE LOOP TO THE UPPER BOX.
3.REMOVE SOCKET RING FROM SOCKET. POSITION GLASS
ON LAMP.
4.SECURE WITH SOCKET RING.
F5453-53 / F5455-53
MOUNTING AND WIRING INSTRUCTIONS
CAUTION:1-TURN OFF ELECTRICITY AT MAIN FUSE BOX BEFORE INSTALLATION.
2-RISK OF FIRE. DO NOT LAMP FIXTURE GREATER THAN WATTAGE
SHOWN ON MAXIMUM WATTAGE LABELS ON FIXTURE.
3-IF YOU ARE UNFAMILIAR WITH ELECTRIC WIRING CALL A QUALIFIED
ELECTRICIAN TO INSTALL THIS UNIT.
CEILING INSTALLATION
WHITE WIRE
GROUND WIRE
BAR STRAP
CEILING
OUTLET BOX
BLACK WIRE
MACH SCREWS( 2)
HEX NUT&WASHER
NIPPLE
CANOPY
RING NUT
FIG 2
CANOPY LOOP
CHAIN
OPEN LINK
FIXTUR E LOOP
RIBBED SIDE
SMOOTH SIDE
WIRE
CROSS- SECTION
FIG 1
1-FASTEN BAR STRAP TO OUTLET BOX WITH (2) SCREWS.
2-ASSEMBLE NIPPLE AND HEX NUT TO BAR STRAP SO THAT THE LOOP WILL
ASSEMBLE AS IN FIGURE 2. LOCK NIPPLE IN PLACE WITH HEX NUT.
3-DETERMINE THE LENGTH OF CHAIN YOU NEED FOR FIXTURE HEIGHT AND
THEN CONNECT THE CHAIN TO THE FIXTURE USING THE OPEN LINK. CLOSE
THE LINK (USE A CLOTH BETWEEN THE LINK AND PLIERS TO PROTECT FINISH).
4-LACE THE WIRES THROUGH THE CHAIN (EVERY OTHER LINK) AND STOP JUST
BEFORE YOU REACH THE CANOPY LOOP.
5-PASS THE RING NUT AND CANOPY DOWN THE CHAIN.
6-A SECOND PERSON MAY BE NEEDED TO ASSIST IN THIS STEP. RAISE THE
FIXTURE TO THE OUTLET BOX AND SCREW THE LOOP ONTO THE NIPPLE.
7-PASS THE REMAINDER OF THE WIRE THROUGH THE CANOPY LOOP AND PULL
OUT OF OUTLET BOX.
8-SPLICE THE RIBBED SIDE OF THE PARALLEL WIRE TO THE WHITE SUPPLY
WIRE FROM THE OUTLET BOX WITH WIRE CONNECTOR (NOT SUPPLIED).
SPLICE THE SMOOTH SIDE OF THE PARALLEL WIRE. TO THE BLACK SUPPLY
WIRE FROM THE OUTLET BOX WITH WIRE CONNECTOR. SPLICE GROUND WIRE
TO SUPPLY GROUND WIRE WITH WIRE CONNECTOR. PUSH ALL WIRES BACK
INTO OUTLET BOX.
9-RAISE CANOPY AND SECURE WITH RING NUT. TURN ELECTRICITY BACK ON.
MSH Series