uBoard Hardware Installation Guide (V2.2) This manual is uBaord hardware installation guide manufactured by PenAndFree Co.,Ltd. 2010 PenAndFree Co.,Ltd. All rights reserved. uBoard is a trademark of PenAndFree Co.,Ltd. All contents of this publication are subject to change. 2010. 7 PenAndFree Co.
Information to user : This equipment has been tested and found to comply with limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment can generates, uses, and radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
uBoard Hardware Installation Guide (V2.2) INDEX 1. Verify Components before Installation ---- 3 2. Station Installation ---- 3 2.1 Connecting USB cable properly ---- 4 2.2 Connection VGA cable properly ---- 4 3. Digital Pen ---- 5 3.1 Key features ---- 5 3.2 Digital pen operation ---- 6 PenAndFree Co.
uBoard Hardware Installation Guide (V2.2) 1. Verify Components before Installation. Before hardware installation, firstly, please check if components listed below are included in the package. If you find missed one, please contact the store you purchased. . 1 2 3 5 6 Item Station Digital Pen Recharging battery Cable Software CD Station Holer Quantity 1 1 1 1 3 Remarks 1M Including Calibration & Board SW 2. Station Installation. 2.1 Connecting USB Cables properly. 2.1.
uBoard Hardware Installation Guide (V2.2) 2.1.2 Connect USB connector to USB port of Computer. Connect USB connector, the other end of USB cable, to the USB port on the computer. If cable length is not enough, please use USB extension cable. 2.2 Connecting VGA cable properly. After connecting USB cable between uBoard station and computer, connect VGA cable between Beam project and the computer. It is the last step for hardware installation.
uBoard Hardware Installation Guide (V2.2) NOTICE: . Notice 1 Avoid using this device in the environment that air is blown directly to receiver from air conditioner or heater.
uBoard Hardware Installation Guide (V2.2) 3.2 Digital Pen operation uBoard digital pen is using rechargeable battery to avoid environment contamination with maximizing user convenience. a. Recharging time & continuous operating time: It takes about 1 hour for full recharge and lasts 20 hours for continuous operating time. b. Automatic power save function: When the pen is idle for 10 seconds since last click, it will automatically enter sleep mode to save battery.
uBoard Hardware Installation Guide (V2.2) 10 sec . 3.2.3 Pen tip change When pen tip is worn-out, it can be replaced with new one. [To remove] [To insert] Turn pen-tip to right or left direction by 90 degrees and then pull it out carefully Insert pen-tip into pen cage and turn it to right or left direction by 90 degrees to lock it. Notice: Possible to overheat, explode, fire or etc.