PT-PEN Installation Guide All contents of this publication are subject to change. 2011.
Information to user : This equipment has been tested and found to comply with limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment can generates, uses, and radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
INDEX 1. Check contents inside ---- 3 2. Install receiver station on laptop ---- 3 3. Product Specification ---- 6 4.
Hardware Installation Guide 1. Check contents inside Please check to see if entire contents are included in package. If not, please contact customer service nearby or store. Station Install CD Deco Fixture Pen Both-side adhesive tapes 2. Install receiver station on laptop (1) Deco fixture – magnetic Place deco fixture underneath the receiver and check attaching position Deco fixture ※ Station has a magnet.
(3) < Install on laptop screen > • Take off the masking tape on the back side of deco fixture. Attach deco fixture on top, right or left side of laptop cover. ※ please confirm station position setting in option menu of driver software (MINT Control). (4) < Connect USB > • Plug USB connector to USB port of PC. • When PC is on after installation, blue light will show on station and PC will automatically recognize device. (5) < Store separated from computer > Keep separate from PC when not being used.
If S/W is not installed, proper operation may not occur even device is successfully installed. Please refer to “Software Installation” section of installation guide and install driver software. < How to confirm whether pen is active > • Upon inserting batteries, press pen tip or pen button in order to activate. • The pen is properly activated, small beep sound created from ultrasonic wave will occur in very close distance to ear.
3. Product Specification Operating size Technology Sampling rate Device standard Resolution 170mm ~ 358mm diagonal ( 16 inch ) Ultrasonic and infrared Over 70Hz HID pen device About 600 DPI (Sampling) / Valid with 0.
Software Installation Guide 1. Install driver software (MINT Control) (1) Insert installation CD into CD-ROM. (2) Installation menu (picture below) will be appeared automatically. Start software installation by selecting “Install” MINT Control. Launch You can use MINT Interactive without installing on your computer. Install Install MINT software on your computer Permanently. Install Install MINT software on your computer permanently.
To delete, click “Start > Programs > PNF > MINT >uninstall MINT”. or click ‘Start > Programs > PNF > PenOnPC > uninstall PenOnPC” (3) MINT Control installation pop-up window will be appeared. [Next]→ [Install] (4) MINT Control is installed successfully. Please finish installation by selecting [finish] button If MINT Control is installed successfully, “MINT Control”, “MINT Interactive”, “MINT Note” icons are appeared on the desktop as shown below.
When calibrating, you should keep the pen grip position as usual. [Calibration] This is a process to execute pen calibration on right, left, upper and lower sections of screen. Click point appeared on screen with pen tip. After mouse cursor and point align, next calibration step will automatically start. (8) Option TAB Pen Touch: adjusting pen flexibility Brush Factor: adjusting thickness at start and stop point.
pen tip where cursor can be seen. - Regular position: Cursor is positioned almost at the same position with pen tip. (9) Screen Mode/ Table Mode/ Note Mode Screen Mode: This mode is used while using the pen directly on LCD screen. Table Mode: This mode is used while putting station on the flat surface such as floor or desk. Note Mode: This mode is used while using MINT Note. (10) Update Click on update within option periodically. It will automatically update MINT Control.
