Operation Guide

1) When using the mobile phone wireless charging,please make sure that the base is
properly connected to the power supply.When placing the mobile phone , the
charging device should be placed face down on the charging area of the base ,
that is,enter the charging state,complete the charging,and take it away.
2) Since each mobile phone has different wireless charging position conditions, if it is
found that it cannot be charged, please try to place the mobile phone with different
orientations ( orremove the protective cover) until the recognition is successful.
Wireless charging method
Wireless Charging
Magic Lamp
1. The core technology is this creative suspension bulb utilizing two driving forces
automatic control systems.
2. When it is unplugged or loses power, the light bulb will attach itsulf to the
suspension device to avoid the problem of a falling light bulb.
3.The multi-function magnetic suspension light can not only be used as a table
or desk lamb but can also wireless charge mobile phones on its base.
4. Please read the instructions carefully. Then you can use the floating bulb very
simply . Follow the safety guidlines contained , which will help avoid safety
accidents.
5. To avoid damage, do not drop any part of this product ( the lamp, base, and
bracket ) .
6. The product should be used on a horizontal, flat surface; otherwise, the bulb
may continually shake.
7. For safety reasons, this product is not suitable for children under 12 years of age.
8. If lamp is not being used for an extended period of time, please place bulb
somewhere safe and do not directly attach to the suspension device.
The product contains accessories
:
pow er supply Instruction manual
Auxiliary tools
Auxiliary tools
bulb power supply
Mobile phone
wireless charging
Base
Magnetic
suspension
device
Touch switch
Power hole
Base light bulb
P
u
l
l u
p
C
e
nter point
weight: 0.7Kg
380mm
150mm
4
7
2
3
52% Charged
6
52% Charged
5
1
·
Place the base on the water platform, connect the power adapter to the base
jack, and plug in the power source;
·
As shown in Figure 3-4, take the auxiliary tool and align it under the suspension
device, then pick up the light bulb with one hand and lean against the auxiliary
tool. When you feel the light bulb has a suspension force, slowly let go of your
hand (be careful not to drop the light bulb), and then Pull out the auxiliary tool
gently, and the bulb installation is completed.
·
As shown in Figure 1, there is a light bulb touch switch on the base table.
Operation guide
Use s tep diagram