• UCI 0 Hearing Aid Sanitizer/ Dryer With Battery Tester #812944027650 HTL-DRYERLED
Overview Hearing aids are electronic devices of high precision and their requirements of use should be strictly observed. Due to the sweat and humidity encountered in daily use, it is especially important to perform daily maintenance. Keeping your hearing aids clean is important. Sweat and earwax built up on hearing aids might allow bacteria to breed, as well as affect the unit's performance. Hearing aids consume battery life.
Technical Specifications 4. Timer Control: 4.1 Selectable drying time settings for 3, 6, 9 hours 4.2 Sterilization time: 30 minutes 5. UV LED specturm: 275nm 6. Battery Indicator: three levels 6.1 Green light - battery power• 1.30V 6.2 Yellow light - battery power• 1.1 SV but < 1.30V 6.3 Red Iig ht - battery power < 1.1 SV 7. Safety protection: 7 .1 Over-temperature & over-heating protection 7.
Functions 1. Constant heating Set the thermostat control at S0'C ±S'C to keep the unit(s) drying. The circuit board of the machine consists of 24 pieces of crystal heating elements set in an intensive array and fixed to the PCB. These heating points make sure the machine is heated in a balanced manor. 2. Sterilization The machine contains a UV LED tube which generates 275 nm UV. The high intensive UV/LED illuminates at a short distance to kill surface bacteria and viruses.
Functions 4.2.1 When the upper cover is not closed properly, the device will not run. 4.2.2 During sterilization, the protective mechanism will cut off the power whenever the cover is opened. The UV/LED tube will be turned off immediately to avoid any hurting of the eyes or skin by light leakage.When the cover is closed, the unit will continue working once again. 5. Main control unit The SCM technology will collect all of the data and distribute it to the CPU.
Operation Sterilizing & disinfecting: The indicator lamp will light up after connecting with the power. Press the sterilization key to sterilize and disinfect. The unit will stop automatically after 30 minutes of runtime. Battery Tester: All kinds of zinc air batteries for hearing aid use can be tested by this machine. Place battery in the test slot; the power remaining in the battery will trigger the correct light to activate. NOTES 1. Remove hearing aid battery prior to use. 2.