5 GHz LTU™ Long-Range Client Radio Model: LTU-LR
• • • • • • • • • • • • • • • Package Contents Installation Requirements Hardware Overview Hardware Installation Connecting Power Accessing the Configuration Interface UNMS Management Installer Compliance Responsibility Specifications Safety Notices Electrical Safety Information Limited Warranty Compliance Declaration of Conformity Online Resources
Package Contents Antenna Feed Center Reflector Panel Side Reflector Panels (Qty. 2) 0 0 Mounting Bracket M8 SEM Screws (Qty. 4) Rear Housing Metal Straps (Qty. 3) Pivot Panels (Qty. 2) Gigabit PoE (24V, 0.5A) with Mounting Bracket Installation Requirements • • • • LTU PtMP AP, such as model LTU-Rocket Phillips screwdriver 13 mm wrench 8 mm socket wrench or screwdriver M4 SEM Screws (Qty.
• Surge protection should be used for all outdoor installations. We recommend that you use two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and the other at the entry point to the building. The ETH-SP-G2 will absorb power surges and safely discharge them into the ground. Note: For guidelines about grounding and lightning protection, follow your local electrical regulatory codes.
Hardware Overview Bottom View 1 2 3 4 LAN LED The LED will light steady blue when an active Ethernet connection is made to the Ethernet port and flash when there is activity. Power LED The LED will light blue when the device is connected to a power source. Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. PoE In [24V] Port This 10/100/1000 Ethernet port is used to connect the power and should be connected to the LAN.
Hardware Installation 1.
2.
3.
4.
5.
