Installation Instructions

LTH-301M
Diagram References
Appearance
Before you begin:
1
3
4
Terminal and Wiring
2
Microphone
Camera
Indicator
Unlock : Green Call: Orange Communicate: White
1 2
1 2
3
4
9
11
5
7
10
8
Drill (ø2.846) and gradienter.
template.
Remove the template from the wall.
holes.
plate with the set screw.
template.
Remove the template from the wall.
according to the screw holes.
plate with the set screw.
1. Power on the device, and connect the device to the network.
2. Enter the IP address into the address bar of the web browser, and click Enter to enter the
Note:The computer and the device should belong to the same subnet.
3. Create and enter a password into the password field.
4. Confirm the password.
performed.
you can use the device.
Default IP Address: 192.0.0.65.
Default Port No.: 8000.
Default User Name: admin.
Access to the Device by Web Browsers
1. In the browser address bar, enter the IP address of the device, and press
the Enter key to enter the login page.
2. Enter the user name and password and click Login.
Unlock Door
Terminals
TF Card Slot 12 Network Interface
Loudspeaker
6
Card Reading Area
TAMPER
NC: Door Lock Relay Output (NC)
NO: Door Lock Relay Output (NO)
COM: Common Interface
GND: Grounding
12 VDC IN: Power Supply Input
AIN1: For the access of Door Contact
AIN2 & AIN4: Reserved
485-: RS-485 Interface (Reserved)
485+: RS-485 Interface (Reserved)
Set Screw
Debugging Port
Note: Debugging port is used for debugging only.
5
Only Mifare card supported, and Mifare card with non-standard shape is recommended.
issued.) can be heard when the issued card amount exceeds the upper limit.
4
1
2 3
1
1
1
2
2. Set the parameters.
Note: If you check Call Management Center and set the call No. as well, call management center has higher privilege
than call No.
3
5
3
4
2
5
Activation
User Name
Password
Confirm
OK
page.
2. Click Issue Card. Present the card on the card reading area.
Issue Card
4
1
2
3
4
7
8
9
10
6
5
11 12
RS-485+
RS-485-
Orange
Yellow
Red
12 VDC
GND
AIN1
AIN2
AIN3
AIN4
NC
NO
Black
White
White
White
Yellow
Blue
COMGreen
GND
GND
Black
Black
White
PRESS
Exit Button
TO EXIT
Reserved
Power
Input
The re comm ende d dist ance f rom th e grou nd lev el is 1. 40
adju stab le dep ends o n the he ight o f body.
102023104
Hole1
Hole2
Hole1
Hole1 Hole1
102.58
1.18
Unit : mm
6.2
39.24
3.45
2
1
3
ScrewsScrew
Villa Door Station
Mounting Plate Mounting Template Wall
1
3
4
2
Screws
Screws
Screw
Villa Door Station
Mounting Plate Protective Shield Mounting Template Wall
This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the applicable
2011/65/EU.
European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new
www.recyclethis.info
www.recyclethis.info
FCC Conditions
1. This device may not cause harmful interference.
EU Conformity Statement
FCC Information
FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.
Vaild password range [8-16]. You can
lowercase, uppercase and special
character for your password with at
least two kinds of them contained.
1 0
Call Call Management Center
LTH-301M LTH-301M-WIFI
IC statement
(1) this device may not cause interference, and
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
minimum distance 20cm between the radiator & your body.
exploité avec distance minimale de 20 entre le radiateur et votre corps.