Produkt: Ersteller: MANUAL Loxone Air Transceiver-Modul Urlhardt, Johannes Manual Loxone Air Transceiver-Modul 1. 2. 3. 4. 5. Introduction 1.1. Abbreviations and Acronyms 1.2. Related Documents Modul Overview Specification 3.1. Electrical Characteristics 3.1.1. Absolute Maximum Ratings 3.1.2. Power Supply 3.1.3. RF Characteristics(1) 3.2. Physical/environmental Characteristics and Outline 3.3. Soldering Profile Agency Certifications 4.1. United States (FCC) 4.2.
Produkt: Ersteller: MANUAL 1. Loxone Air Transceiver-Modul Urlhardt, Johannes Introduction 1.1.
Produkt: Ersteller: MANUAL PCB Printed Circuit Board PER Package Error Ratio RAM Random Access Memory RF Radio Frequency RPC Reduced Power Consumption RTS/CTS RX Request to Send/ Clear to Send Receiver SMA Surface Mount Assembly SoC System on Chip SPI Serial Peripheral Interface SW Software TTM Time-To-Market TX Transmitter UART Universal Asynchronous Receiver/Transmitter USART Universal Synchronous/Asynchronous Receiver/Transmitter USB Universal Serial Bus ZigBee, ZigBee PRO
Produkt: Ersteller: MANUAL 2. Loxone Air Transceiver-Modul Urlhardt, Johannes Modul Overview The Loxone Air Transceiver-Modul is a low power IEEE 802.15.4/6LoPAN module for Loxone Air Smart Home Products.
Produkt: Ersteller: MANUAL 3. Loxone Air Transceiver-Modul Urlhardt, Johannes Specification 3.1. Electrical Characteristics 3.1.1. Absolute Maximum Ratings Parameter Minimum Maximum Voltage on any pin, except RESET with respect to ground -0.3 V 3.6 V (VDD MAX) Input RF level +10dBm Current into VCC pins 200mA Notes: 1. Absolute Maximum Ratings are the values beyond which damage to the device may occur.
Produkt: Ersteller: Loxone Air Transceiver-Modul Urlhardt, Johannes MANUAL 3.1.3.
Produkt: Ersteller: MANUAL 3.3. Soldering Profile Loxone Air Transceiver-Modul Urlhardt, Johannes The J-STD-020C-compliant soldering profile is recommended according to the following table. Profile Feature Green Package Average ramp-up rate (217°C to peak) 3°C/s max. Preheat temperature 175°C ±25°C 180s max.
Produkt: Ersteller: MANUAL 4. Loxone Air Transceiver-Modul Urlhardt, Johannes Agency Certifications 4.1. United States (FCC) This equipment complies with Part 15 of the FCC rules and regulations. To fulfill FCC Certification requirements, an OEM manufacturer must comply with the following regulations: 1. Modules must be installed by original equipment manufacturers (OEM) only. 2. The module must only be operated with antennas adhering to the requirements defined in section Supported Antennas. 3.
Produkt: Ersteller: MANUAL 4.2. Loxone Air Transceiver-Modul Urlhardt, Johannes Innovation, Science and Economic Development Canada (ISED) Compliance statements This device complies with ISED licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Produkt: Ersteller: MANUAL Loxone Air Transceiver-Modul Urlhardt, Johannes the Loxone Air Transceiver-Modul module must either use the antenna mentioned above or must use an antenna with an omnidirectional radiation pattern and a gain being less than or equal to 2 dBi.
Produkt: Ersteller: MANUAL 5. Loxone Air Transceiver-Modul Urlhardt, Johannes Revision History Doc. Rev. Date Comments 1.
