Quick Start Manual

ManualsBrandsLorex ManualsAccessoriesLorex Wireless baby camera

www.lorextechnology.com

LW2031AC1 Quick Start Guide_R1 Page 1

Contents:

Power Adapter

Camera

Before you install the camera, carefully plan where and how it will be positioned, and where

you will route the cable that connects the camera to the power adaptor.

Avoid installing in a location which requires the wireless signal to pass through cement, concrete

and metal structures. This will reduce the transmission range.

TIP

1 Plug the AC power connector from the power adapter into the

AC adapter port on the camera.

2 Connect the power adapter to a power outlet.

3 The charging LED glows red to indicate the camera is charging.

Charging your camera

NOTES:

• The Status LED on the camera flashes when there is

approximately 30 minutes of battery life left. Charge the camera

for 6 consecutive hours to charge completely.

• Only use the included power adapter to charge the camera(s).

It is recommended to charge your camera before initial use.

WIRELESS ACCESSORY CAMERA

LW2031AC1

QUICK START GUIDE

SIMPLY AWARE

™

CONNECT

1 Turn off the camera that you wish to pair.

2 Select the channel that you wish to pair up the camera by pressing the

1, 2, 3 or 4 button on the handheld monitor.

3 Place the camera that you wish to pair one foot apart from the

handheld receiver.

4 Press the Menu button on the monitor.

5 Press

(up) or (down) and select Pair, then press the OK button.

6 Turn on the camera and wait 15 seconds for the camera to pair up.

When the camera has been successfully paired with the monitor, a

“Device Found” message appears.

Pairing your camera to the handheld monitorOPTIONAL:

TIP

• Immediately after successful pairing, move the camera and monitor apart to avoid speaker feedback.

Power

Down

NOTE:

• Adding cameras through the Gateway automatically adds the camera to the handheld monitor. If you wish to pair the camera

directly to the handheld monitor instead, please see below. If you have paired via the Gateway, you may skip this step.

1 Turn the camera on and place it one foot apart from the Gateway.

2 Log into the Gateway* using your computer and click the Camera tab.

3 Turn on the camera that you wish to pair.

4 Under “Default”, select the check box beside the channel that you wish to pair the camera to.

5 Click the Pairing button. When the camera icon glows green (

), the camera has been paired.

* Refer to the LW2031 Users Manual for detailed instructions on logging into your Gateway.

Pairing your camera to the Gateway