Quick Start Manual

www.lorextechnology.com

WL2110KIT: Installation Instructions

Step 1 of 2: Set up the antenna and wireless receiver

1. Connect the extension cable (included with the antenna) to the SMA connector on the

wireless receiver as shown below.

2. Connect the other end of the extension cable to the antenna.

3. Connect the power adapter to the wireless receiver’s DC port. Connect the wireless receiver

to a DVR/monitor.

NOTE: For antenna mounting instructions, refer to the antenna installation guide.

SMA connector

Extension cable

Final Result

Antenna

Wireless Receiver

DVR /

Monitor

Power connector

Extension

cable

PAGE 1
www.lorextechnology.com WL2110KIT: Installation Instructions Step 1 of 2: Set up the antenna and wireless receiver 1. Connect the extension cable (included with the antenna) to the SMA connector on the wireless receiver as shown below. SMA connector Extension cable 2. Connect the other end of the extension cable to the antenna. 3. Connect the power adapter to the wireless receiver’s DC port. Connect the wireless receiver to a DVR/monitor.
PAGE 2
Step 2 of 2: Pair the camera and receiver To pair the camera to the receiver: 1. Power on the camera and receiver. 2. On the receiver, press and hold the Pairing button for 5 seconds to activate the pairing function. • The on-screen displays informs you that you have 30 seconds to press the Pair button on the camera. Pairing button 3. Press and hold the Pair button underneath the antenna on the back of the camera.