Lorex Home Center Extender AX62TR Series Quick Start Guide lorex.
Welcome! From all of us at Lorex, we welcome you to our community – thanks for your purchase of the Lorex Home Center Extender. We designed this product with you in mind, to extend the performance and range of our new Lorex Home Center. Here’s how to get started.
What you’ll find in the box Lorex Home Center Extender USB Power Pack
Overview LED indicator Reset / disable alarm button Speaker USB power port
Placement of the Lorex Home Center Extender Based on factors such as the distance between your devices, the size of your home, environmental conditions, physical obstructions, and how much frequency interference there is in your area, here are some placement recommendations for the extender/repeater. Find a central location. • The ideal location to place the extender/repeater is halfway between your Lorex Home Center and your other Lorex device(s) that need better Wi-Fi.
Placement of the Lorex Home Center Extender • Limit the amount of walls, ceilings, and other major obstructions between the extender/ repeater and your other Lorex device(s). • Make sure that the outlet that you choose has a strong Wi-Fi signal from your home router.
Device Setup Attention: Setup the Lorex Home Center before going through these steps. 1. Plug the USB power cable into the extender/repeater. Then plug the power adapter into a wall outlet to power on. Note: The LED light will flash blue when ready to pair. 2. Unlock the Lorex Home Center and tap on Device Manager in the homescreen. 3. Go to the Repeater tab, then tap + on the top right to pair. 4. In the Device Setup screen, tap Repeater and tap Next. 5.
Device Settings You can view the extender/repeater’s device information or configure the settings for sound, LED light status, and firmware updates, all through the Lorex Home Center. To open the extender/repeater’s Device Settings: 1. Unlock your Lorex Home Center and tap the extender/repeater displayed on the homescreen. 2. In the extender/repeater’s device screen, tap the three dots settings.
Sound Settings There are two audio options that can be enabled or disabled in the extender/repeater’s sound settings. 1. Event Notification Chime: The extender/repeater will sound the event notification chime when a camera has detected motion or a sensor has been triggered. The chime is disabled by default. 2. Doorbell Chime: When someone rings the doorbell, the extender/repeater will sound the doorbell chime. The chime is enabled by default.
Light Status Indicators See the table below for definitions of the extender/repeater’s LED light status indicators: • Powered off • LED status is turned off (off) • Powered on • Pairing successful • Strong Wi-Fi signal strength (flashing) Pairing with other devices Resetting (flashing) (flashing alternatively) Disconnected from the Lorex Home Center Firmware update in progress Weak Wi-Fi signal strength (flashing) Alarm has been triggered
Troubleshooting 1. After installing the extender/repeater, I still have low signal strength on my camera(s). Make sure that your faraway camera(s) are connected to the extender/repeater directly. To check this, go to the Lorex Home Center’s Device Manager settings from the homescreen and see if your camera(s) are still connected. If you’re finding that your camera(s) are still connected to the Lorex Home Center and not to the extender/repeater, then you will need to do the following: 1.
Lorex Home Center Extender For up-to-date information and support, visit help.lorex.com/series/LHCE. Important: • The Lorex Home Center Extender is rated for indoor use only. Do not use outdoors. • Only use with included power supply. • A Lorex Home Center is required to operate the Lorex Home Center Extender. FCC NOTICE THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.