User Manual

User Manual
(PWM03)
Please read over carefully and keep this manual for your
records
Thank you for choosing our Magnetic wireless Power Bank
Product Introduction Wireless Charging the phone
Standard accessories
Wireless Charging area
Specifications
User ManualType-C cable
Devices built-in wireless charging receiver and support fast
wireless charging
(Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei
P30 Pro/Mate30/Mate30 Pro/P40 Pro stand charger for
Iphone XS Max/Xr/11/11 Pro/11 Pro Max and all Qi-enabled
devices)
Wireless applicable device
Magnetic charging equipment
(Iphone 12mini/12/12Pro/12Pro Max)
(Iphone 13mini/13/13Pro/13Pro Max)
put the device on the middle of the phone back, it can be
adsorbed automatically and charging the phone at the
Magnetic
Wireless Power Bank
ON/OFF
Fault indicator
Type-C In/Output
Battery indicator
Charging the device
1. Connecting the Type-C interface of the Magnetic wireless
Power Bank to the power adapter
Type-C Input
Type-C Output
Wired Charging the phone
Model No.: PWM03
104×70.15×14.5mm
Capacity:
Type-C Input:
Type-C Output:
Wireless Output:
5V3A,9V2.2A,12V1.67A
5V3A,9V2.2A,12V1.67A
2.The Battery indicator glow white in charging mode
Use the charging cable to connect the magnetic wireless
power bank and your phone
≥75%
≤3-6mm
10000mAh/
3.85V/38.5Wh
5W，7.5W，10W，15W
≈192G (NW)
For a more accurate display of the power level, it is
recommended to perform two charge/discharge cycles.
When using wireless charging, the wireless charging indicator
is always on; after disconnecting from the phone, the wireless
charging indicator flashes slowly for 10 seconds and then turns
off; when the wireless charging area touches a metal foreign
object, the wireless charging indicator flashes quickly.
NOTE: This equipment has been tested and found to comply with
the limits for aClass B digital device, pursuant to part 15 of the
FCC Rules. These limits aredesigned to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.