User's Manual

102*68.7mm
Magnetic Wireless Battery
User Manual
Please read over carefully and keep this manual for your
records
Thank you for choosing our Magnetic wireless Power Bank
Product Introduction
1. Connecting the Type-C interface of the Magnetic wireless
Power Bank to the power adapter
2.Battery light blinking in charging mode
For a more accurate display of the power level, it is
recommended to perform two charge/discharge cycles.
Charging the device
Wireless Charging the phone
put the device on the middle of the phone back, it can be
adsorbed automatically and charging the phone at the same
time
When the wireless charging area touches a metal foreign
object, the yellow battery indicator flashes rapidly
Wired Charging the phone
Use the charging cable to connect the magnetic wireless
power bank and your phone
Standard accessories
Specifications
User ManualType-C cable
Devices built-in wireless charging receiver and support fast
wireless charging
(Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei
P30 Pro/Mate30/Mate30 Pro/P40 Pro stand charger for
Iphone XS Max/Xr/11/11 Pro/11 Pro Max and all Qi-enabled
devices)
Wireless applicable device
Magnetic charging equipment
(Iphone 12mini/12/12Pro/12Pro Max)
(Iphone 13mini/13/13Pro/13Pro Max)
Model No.: L-WP-05A9
104×70×9mm
Capacity:
Type-C Input:
Type-C Output:
Wireless Output:
5V3A,9V2.2A,12V1.67A
5V2.4A,9V1A,12V1A
≥75%
≤3-6mm
5000mAh/3.85V/19.25Wh
5W，7.5W
≈128G (NW)
Battery indicator
Type-C In/Output
Wireless Charging area
ON/OFF
Type-C Input
Type-C Output
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment. This device complies
with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.