User's Manual

User Manual
(L-WP-05A6)
Magnetic
Wireless Power Bank
Standard accessories
Specifications
User ManualType-C cable
Devices built-in wireless charging receiver and support fast
wireless charging
(Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei
P30 Pro/Mate30/Mate30 Pro/P40 Pro stand charger for
Iphone XS Max/Xr/11/11 Pro/11 Pro Max and all Qi-enabled
devices)
Wireless applicable device
Magnetic charging equipment
(Iphone 12mini/12/12Pro/12Pro Max)
(Iphone 13mini/13/13Pro/13Pro Max)
Model No.: L-WP-05A6
83×60×13.7mm
Capacity:
Type-C Input:
Type-C Output:
Wireless Output:
5V3A,9V2.2A,12V1.67A
5V3A,9V2.2A,12V1.67A
≥75%
≤3-6mm
5000mAh/
3.85V/19.25Wh
5W，7.5W，10W，15W
≈122G (NW)
Charging the device
1. Connecting the Type-C interface of the Magnetic wireless
Power Bank to the power adapter
Type-C Input
2.The Battery indicator glow white in charging mode
For a more accurate display of the power level, it is
recommended to perform two charge/discharge cycles.
Wireless Charging the phone
put the device on the middle of the phone back, it can be
adsorbed automatically and charging the phone at the same time
When using wireless charging, the wireless charging indicator
is always on; after disconnecting from the phone, the wireless
charging indicator flashes slowly for 10 seconds and then turns
off; when the wireless charging area touches a metal foreign
object, the wireless charging indicator flashes quickly.
Type-C Output
Wired Charging the phone
Use the charging cable to connect the magnetic wireless
power bank and your phone
Please read over carefully and keep this manual for your
records
Thank you for choosing our Magnetic wireless Power Bank
Product Introduction
Wireless Charging area
Wireless charging indicator
Battery indicator
ON/OFF
/OutputType-C In
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is noguarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.