ASSEMBLY INSTRUCTIONS Description : MISSION ARM CHAIR Printed in Vietnam -1-
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free.
PART LIST When unpacking, please be careful not to discard any parts with the packaging.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Short Bolt (M6 x 40mm) 3 Sketch NO Description Qty 3 2 Medium Bolt (M6 x 60mm) 4 Long Bolt (M6 x 80mm) 4 4 Short Screw (M3.5 x 15mm) 2 5 Medium Screw (M4 x 35mm) 4 6 Long Screw (M4 x 50mm) 6 7 Lock Washer (6.5 x 11mm) 19 8 Large Flat Washer (6.
STEP 1 Insert arm supports (G) into arms (H) as shown below. STEP 2 Attach seat frame (B) to the back (A) with bolts (1) and (3), and washers (7) and (8), as shown below. Tighten with Allen key (9).
STEP 2 Attach front legs (D) to the seat frame (B) with bolts (2), and washers (7) and (8) as shown below. Tighten with Allen key (9). Attach middle stretcher (F) to side stretchers (E) with screws (4). Then attach side stretchers (E) to front and back legs with screws (6) as shown below. Tighten with a screwdriver. STEP 3 Attach arms support (G) to seat frame with bolts (14), and washers (7) and (12) as shown below. Tighten with Allen key (9). Then use nuts (10), and washers (7) and (8) as shown below.
STEP 4 Attach the seat (C) to top of the seat frame (B) with screws (5) as shown below. Tighten with a screwdriver. Then insert wood plugs (13) over bolts to cover them.