Assembly Instructions

ASSEMBLY INSTRUCTIONS
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS
TOOLS & MATERIALS REQUIRED
· Adjustable Wrench · Phillips Head screwdriver · Wire Cutters
· wiring cutters · Pre-mixed concrete(for soft ground installation)
· Wiring supplies as required by Electrical Code
CAUTION
Before assembling your lighitng fixture,refer to the section section
ELECTRICAL CONNECTIONS
.If you feel
you do not have enough electrical wiring experience,refer to a do-it-yourself wiring handbook or have your fixture
installed by a qualified licensed electrician.
GENERAL
1. To ensure the success of the installation,be sure to read these instructions thoroughly before beginning.
2. All electrical connections must be in accordance with local codes,ordinances,or the National Electric Code.
If you are unfamiliar with methods of installing electrical wiring,secure the services of a qualified licensed
electrician.
3. Before starting the installation,disconnect the power by turning off the circuit breaker or by removing
appropriate fuse at fuse box.Turning the power off at the light switch is not sufficient to prevent electrical
shock.
UNPACK THE FIXTURE
Check the contents of the box.You should receive:
· Base · Lower & upper stem
· Mounting hardware package · Fixture assembly(s)
PREPARE THE FIXTURE
NOTE:First turn off electricity
1. Thread the 3 "L" bolts into the mounting plate so they protrude 1-1/2 inches through the opposite side of the
mounting plate.Set the mounting plate assembly with the "L" bolts down into wet concrete,making sure it is
level and anchored securely.Make sure the electrical supply wiring is long enough to pass through the length
of the pole sections up to the connection of the fixture assembly.Allow concrete 24 hours to cure prior to
installation of the fixture.
2. Pass the supply wiring through the base,lower stem and upper stem.
3. Make electrical connections - SEE BELOW.
ELECTRICAL CONNECTIONS 120V～, 60Hz
1. Connect the white wire(s) from the fixture to the white wire of the supply circuit.Connect the black wire(s)
f rom the fixture to the black wire of the supply circuit.Connect the green(or bare copper) colored wire to the
grounding conductor of the supply circuit.
2. Use UL/CSA Listed wire connects suitable for the size,type,and number of conductors.
3. No loose strands or loose connestors wires should be present.
FINAL ASSEMBLY
1. Install bulb:(not included)
CAUTION: Refer to the relamping label located near lampholder for recommended maximum wattage.Do
not exceed recommended wattage.
2. Place the top covers on the lamp bodies and secure them with decorative nuts.
3. Put the exposed wiring into upper stem carefully.Turn the upper stem to fixture assembly until tight.
4. Thread the lower stem into upper stem.
5. Thread the lower stem into the base.
6. Place the whole fixture assembly on the mounting plate and secure with spring washers and decorative nuts
provided.
7. Use the weather resistant caulk to seal around the side perimeter of base.
8. Restore electricity and check the operation of your lighting fixture.
Bulb(Not Included)
Machine Screw
Hex Nut
Machine Screw
Ground Wire
Black Wire
White Wire
Decorative Nuts
Assembly Screw