Assembling & Installation Instructions

ManualsBrandsLongshore Tides ManualsCoastal SconcesArtique 2-Light Armed Sconce

For Wall Mount Fixture

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

MOUNTING THE FIXTURE

Installation (see fig.1)

1. Disconnect power at main electrical panel before

installation.

2. Thread the two mounting screws about 1/4” into the

pre-drilled holes in the mounting plate, spaced about the

same distance apart as the holes in the fixture back plate.

Attach the mounting plate to the junction box using two

junction box screws. The side of the mounting plate

marked “GND” must face out. The junction box is not

included.

3. Guide fixture wires through hole in center of mounting

plate.

4. Follow wiring instructions carefully (see fig.2)

5. Place the fixture body (C) over the mounting plate,

aligning the holes with mounting screws, then lock it

securely with the ball nuts(D).

6. Attach the shade (B) to the lamp holder , lock it securely

with ring (A).

7. Install the light bulbs in accordance with the fixture’s

specifications. DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

Wiring (see fig.2)

1. Connect the electrical wires as follows. Connect the

Black wire from the fixture to the black house (hot)

Wire. Connect the white wire from the fixture to the white

(neutral) house wire. Make sure all wire nuts are secured.

You may wrap the connections with electrical tape. If

your outlet box has a ground wire (green or bare copper)

connect fixture’s ground wire to it. Otherwise attach the

bare copper fixture wire to the green ground screw on the

mounting plate.

2.Tuck the wire connections neatly into the wall junction

box.

Fig.1

Fig.2

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT