USER MANUAL LRS Beacon MODELS: ZB-Beacon Long Range Systems, LLC. LRSUS.COM | 800.437.4996 | 214.553.
TABLE OF CONTENTS General Information 3 Setup and Use 3 Product Specifications 4 Cleaning 4 Service Questions and Answers 5 What To Do If The System Malfunctions 5 System Repair After The Warranty Expires 5 Ordering Additional Pagers 5 Warranty 5 FCC Information 6 2
GENERAL INFORMATION The LRS ZB-Beacons are used in conjunction with the LRS Table Tracker systems. They are used as an on-premise locating system to increase efficiency by identifying customer’s’ location, typically to deliver services or goods. Beacons are powered by AAA batteries, water resistant, and can flash when the user presses the button during configuration. SETUP AND USE To begin using your beacons, power them up by adding batteries. Batteries Installation 1.
PRODUCT SPECIFICATIONS Required Voltage: 2 x 1.5V Battery Type: Alkaline, 2 x AAA Battery Charge Life: Approximately 18 months (depends on environment). Operating Range: Up to 100 meters Dimensions: 4.92” x 2.03” x 1.00” CLEANING LRS ZB-Beacons are made from industrial-strength, polycarbonate material. However, this material is susceptible to hairline cracking if non-approved cleaners are used. When cleaning LRS ZB-Beacons, you should only use ETHYL ALCOHOL (ethanol) or ISOPROPYL ALCO- HOL-BASED CLEANERS.
SERVICE QUESTIONS AND ANSWERS What to do if the system malfunctions Should your locating system ever fail to function properly, refer to the previous troubleshooting section. If you’ve followed all the steps and requirements and your system is still inoperable, you may submit a support request at support.LRSUS.com or call Long Range Systems at (800) 437-4996 Monday through Friday 8:30 am to 5:00 pm Central Time. For after hours inquiries, please follow the instructions on the support line.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
