Posey Sitter II Wireless Nurse Call User Manual Installation, Warranty, and Service Information J. T. Posey Company 5635 Peck Rd., Arcadia, CA 91006-0020 TEL. 800-44-POSEY – 626-443-3143 – FAX 800-767-3933 www.posey.
Sitter II Posey Sitter II Alert and Staff Paging TABLE OF CONTENTS Warranty ................................................................................1 General Information .............................................................2 Installation and Setup ..........................................................2 Installation Procedure.......................................................................................................................................2 Installation Checklist.....
Sitter II GENERAL INFORMATION The Sitter II is a multi-purpose on-premise paging system. This unit plugs into an existing Posey alert system to provide secondary alert to the main hard wire system The pass through security contact alerts a staff pager of a call to the nurse station. A test push button is available ensures the system operation and also is used as a page acknowledged button. Built in rechargeable batteries ensure operation in event of power outage.
Sitter II Basic Operating Instructions Connect the Sitter II to your computer and set the security sensor input to page your pager(s). When the sensor is activated, your pagers will be called. Some possibilities are (see your programming instruction): PROGRAMMING Basic Procedure Note: Systems are not programmed when shipped. The following describes the basic programming procedure. 1. 2. 3. 4. 5. 6. 7. 8. Install the Sitter II programming software on your computer. Start the program. Connect the 7.
Sitter II Programming Pagers The Program Pager ID Screen sets up and loads the pager functions into the staff pagers. The serial cable must be connected from the computer to the Sitter II. To program Over the Air Programmable pagers (Note: Non Over the Air Programmable Pagers are programmed on a separate fixture): 1. Be sure the pagers have new batteries and are turned off (the word OFF appears in the display). 2.
Sitter II SITTER II SPECIFICATIONS Specification Description: The unit is a low power transmitter that generates NBFM signals to UHF paging receivers. Required voltage: One 7.5-VDC battery charger for the transmitter. Operating Frequency: 467.750MHz. Modulation Rate: Maximum of 1200bps Transmit Power Within CFR 47 part 15 limits for an intentional radiator. Signal Encoding: POCSAG encoded.