User's Manual

ManualsBrandsLong Range Systems ManualsElectronicsPRONTO

Each button on the one or six button PRONTO can be programmed to send a unique message

to separate pagers or group of pagers. Both the six-button and one-button models can also

send a specific message for an external switch or sensor.

Installation

To put the PRONTO in operation:

Note: If your Pronto is not already programmed, refer to the programming guide first.

1. Install the 2-batteries in the Pronto (note the positive and negative end)

2. Locate and install the mounting bracket where it is to be used. (use screws, straps

or velcro)

3. Position the unit into the notches in the mounting bracket and press until latch

engages.

4. Turn on the pager (refer to the pager booklet).

5. Press the button(s) on the PRONTO to test that the pager is receiving the messages.

Normal Operation

Press a button

the pager will receive the message.

Optional Power Supply

The PRONTO may also be powered by an optional external power supply. Please contact Long

Range Systems for more information. WARNING: Connection of an incorrect power supply will

void the warranty.

Long Range Systems

PRONTO Quick Guide

PRONTO

™

Six and One Button Paging System

QUICK SETUP & OPERATION

Summary of content (6 pages)

PAGE 1
PRONTO ™ Six and One Button Paging System QUICK SETUP & OPERATION Each button on the one or six button PRONTO can be programmed to send a unique message to separate pagers or group of pagers. Both the six-button and one-button models can also send a specific message for an external switch or sensor. Installation To put the PRONTO in operation: Note: If your Pronto is not already programmed, refer to the programming guide first. 1.
PAGE 2
Programming Your Pronto 1. Locate the 4-pin connector. 2. Connect the USB probe with special 4-pin connectors. 3. Plug into the PRONTO with 4-hole location. 4. Connect the USB plug to the PC. 5. Execute the PC program named “LRS Programmer”. 6. Click “New Table” to edit the messages associated with each button.
PAGE 3
7. Click “Edit” in the corresponding entry for message re-definition. 8. Click “Global Configuration” for configuration setting.
PAGE 4
Six Button Front Six Button Back One Button Front One Button Back O Long Range Systems 4 PRONTO Quick Guide
PAGE 5
FCC Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 6
WARRANTY Long Range Systems LLC warrants this product against any defects that are due to faulty material or workmanship for a one year period after the original date of consumer purchase. The warranty does not include damage to the product resulting from accident, misuse, improper electrical connection, or failure to charge the product within 30 days of receipt. Rechargeable pagers are required to stay on charge while not in use.