User's Manual

AGILON AL-V5 CAR ALARM MANUAL
Button Press function Conditions
1
0.5 seconds Arm/door lock
Sound Car finding
Stop alarm
Remote lock doors
Alarm is disarmed
Alarm is being armed
Alarm is sounding
While driving
2 seconds panic Anytime
2
0.5 seconds Disarm/door unlock
Remote unlock doors
Stop alarm from sounding and disarm
Alarm is being armed
While driving
Alarm is sounding
2 seconds Open trunk Any state
1+2 0.5 seconds Enter ACJ ACC on
3
0.5 Silent arming
Silent Car finding
Stop alarm
Alarm is disarmed
Alarm is being armed
Alarm is sounding
2 seconds Exit ACJ In anti car-hijacking
1+3 2 seconds Enter/exit valet mode Disarming mode
4
0.5 seconds panic Anytime
BASIC FUNCTIONS
1、Arm
Press "
" button of remote control for 0.5 second. the turning light will flash one time, and siren will beep one time, car
door will be locked automatically, and status indicator LED will flash slowly. If the door is not closed properly, the siren
will beep three times, car light will flash three times. Indicator LED will flash rapidly.
If the ignition key stays at ON position, there is only locking function.
2、Mute arming
Press "
" button of remote control for 0.5 second. The turning light flash one time without siren sound, door locked,
status indicator LED flash slowly after arming. if the door is not closed properly, car light will flash three times, indicator
LED will flash rapidly.
3、Disarm
Press "
" button remote control for 0.5 second. The turning light flash two times, siren sound two times, car door will be
unlocked automatically, If the car door is not opened within 40 seconds after disarming, the car will return to arming
status.
If the ignition key stays at“ON” position, there is only unlocking function.
4、 Sound car finding
Under arming status., press "
" button of remote control for 0.5 second, Siren sound one time, turning light flash 10
times. Press "
" button to stop finding to disarm and unlock.
5. Silent car finding
Under arming status , press "
" button of remote control for 0.5 second, the turning light flash 10 times without siren
sound. Press "
" button to stop finding to disarm and unlock.
6. Stop alarming
Under alarm status, press button "
" or " " of remote control for 0.5 second, turning light will stop flashing, siren
will stop alarming.
7. Trunk release
Under any state, press the button "
" of remote control for 2 seconds. Trunk will be released.
Note: It is only available for the car equipped with trunk release switch.
8. Emergency panic alarm
Press the button "
" of remote control for 0.5 second or button for 2 seconds. Siren continue alarming, turning
light continue flashing, indicator LED will flash rapidly, this status will keep for 30 seconds. Press "
" or " " to stop
alarming.
9. Anti-hijack (Use J3 to select this function)
When engine is running, press the button "
" & " " of remote control for 0.5 second, if the door was opened then
closed within 10 seconds, indicator LED will flash rapidly, timing will start, if the door wasn't opened within 10 minutes,
anti-hijack function will be cancelled.
After 60 seconds, siren will sound, engine will be stopped and alarming, turning ignition key to OFF position, alarm will
be stopped. Turning ignition key to ON position, it will alarm again. Press the button "
" of remote control for 2 seconds
to exit anti-hijacking or exit anti-hijacking through emergency disarming.
ALARM STATE DESCRIPTION
1. Shock alarm
The system shall begin to detect the shock sensor after 3 seconds of arming, if one light shock is detected, the siren shall
sound and parking lights shall flash for 2 seconds（the siren sound is contiously 2 seconds, not 2 times）. If heavy shock is
detected, the siren shall keep sounding immediately but without the 3 seconds bypass time, the siren sound is continously
sounding same as door-open/ACC trigger, and parking light shall flash fast for 30 seconds; if the alarming trigger stops,
the siren and parking light shall also stop acting.
2. Door-opened alarm
The system shall begin to detect the state of the car door after 3 seconds of arming, if the door is opened, the siren shall sound and
parking light shall flash fast for 30 seconds to warn. It shall stop after 30 seconds or once the alarming trigger is stopped.
3. Ignition alarm
The system shall begin to detect the state of the ignition key after 3 seconds of arming, if the ignition key is staying on , the
siren shall sound and parking light shall flash fastly continously. It shall stop once the key is turned off.
ADDITIONAL FUNCTIONS
1. Auto rearming
After disarming, if the door was not opened or engine was not started, indicator LED flash rapidly, the car will be armed
and the door will be locked automatically after 40 seconds, the siren shall chirp one time and the parking light shall flash
one time to indicate the entry of arming.
2. Passive arming (use J2 to select this function)
After ACC off, open then close the last door, main module will arm the car automatically after 40 seconds, the siren shall
chirp one time and the parking light shall flash one time to indicate the entry of arming. If opening the door and closing it
again within 40 seconds, it will re-count the time. If starting the car within 40 seconds, this function will be cancelled.
3. Automatic central door lock
When driving, doors will be automatically locked upon first brake Turn ignition OFF to unlock doors.
4. Door-opened warning
If the door is opened after the car is disarmed, the parking lights will flash continuously for 30 seconds to warn the other
drivers behind.
5. Memorize triggered alarm
If the alarm is triggered, the system will memorize triggered alarm under arming state, when disarming, turning lights will
flash four times, siren will beep four times, reminding the driver to check the car.
6. State memory
The alarm system will memory the condition before the power is cut off.
7. Emergency disarming
If car can't be disarmed owing to the losing of the remote control, invalidation of remote control or any other reason, you
can open the door lock using the original key under arming, then insert the key into the ignition switch, continue turning
the key from OFF to ON 8 times rapidly, then stop at ON position, 2 seconds later, siren sound 2 times, turning light flash
2 times, arming is cancelled, you can drive the car normally.
8. Code memorizing
Under the disarming state, continue turning the ignition key from OFF to ON 6 times rapidly, then stop at ON position at
last, 2 seconds later, siren sound 3 times, press any button of remote control to do code memorizing within 10 seconds, up
to three remote control can be memorized. After one remote control was memorized, the system will keep time delay for
10 seconds. Turning the key to OFF position, it will exit the memorizing process or it will exit memorizing process
automatically after 10 seconds.
9. Valet mode
Under disarming state, press button 1 and button 3 simultaneously for 2 seconds (同时按 1+3 键 2 秒), the system shall
enter the valet mode, LED keeps on, in this condition, there is no alarming function, you can only lock and unlock the car
doors. There is no siren sound when lock and unlock the door. It was usually used under repairing and washing or
somebody can keep an eye on the car. If you want to exit to this mode, use the same way to exit, 2 seconds later, LED light
will turn off, you can operate arming and disarming then
PROGRAMBLE FEATURES
Function Jumper on Jumper off
Jumper 1 Door lock time 0.5 seconds 3.5 seconds
Jumper 2 Passive arming with without
Jumper 3 Anti-carjacking Without With
When program the above features, the system needs to be powered off at first, then put the jumper on or take the jumper
off to select the feature. Then Power the system on, the selected feature would be functional.