User's Manual

ManualsBrandsLong-E Technology ManualsElectronicsRemote Control

TA33 for V585 CAR ALARM MANUAL

Button Press Function Conditions

0.5 second

Arm/door lock

Sound Car finding

Stop alarm

Remote lock doors

CARJACK

Alarm is disarmed

Alarm is being armed

Alarm is sounding

While driving

Ignition is ON

2 seconds Panic Anytime

0.5 second

Disarm/door unlock

Remote unlock doors

Stop alarm from sounding and disarm

Alarm is being armed

While driving

Alarm is sounding

0.5 second

Silent arming

Silent Car finding

Stop alarm

Alarm is disarmed

Alarm is being armed

Alarm is sounding

2 seconds Trunk Release Anytime

BASIC FUNCTIONS

1、Arm

Press " " button of remote control for 0.5 second, the turning light will flash one time, and siren will beep one time,

car door will be locked automatically, and status indicator LED will flash slowly. If the door is opened when arming,

the door sensor is ignored for 5 seconds or 60 seconds (option 4). If the door is still opened after 5 seconds or 60 seconds,

the siren and parking lights shall act 3 times indicating the door is not close properly, the LED shall flash rapidly, then

the door switch shall be bypassed. It will automatically return to arming status immediately once it is closed.

If the ignition key stays at ON position, there is only locking function.

2、Mute arming

Press " " button of remote control for 0.5 second, the turning light flash one time without siren sound, door locked,

status indicator LED flash slowly after arming. If the door is opened when arming, the door sensor is ignored for 5

seconds or 60 seconds (option 4). If the door is still opened after 5 seconds or 60 seconds, the parking lights shall act 3 times

without siren sound, indicating the door is not close properly, the LED shall flash rapidly, then the door switch shall be

bypassed. It will automatically return to arming status immediately once it is closed.

3、Disarm

Press " " button remote control for 0.5 second, the turning light flash two times (option 11), the siren sound two

times, car door will be unlocked automatically. If the car door is not opened within 40 seconds after disarming, the car

will return to arming status.

If the ignition key stays at ON position, there is only unlocking function.

4、Sound car finding

Under arming status, press " " button of remote control for 0.5 second, Siren sound one time, turning light flash 10

times. Press " " button to stop finding to disarm and unlock.

5、Silent car finding

Under arming status, press " " button of remote control for 0.5 second, the turning light flash 10 times without siren

sound. Press " " button to stop finding to disarm and unlock.

6、Stop alarming

Under alarm status, press button " " or " " or " " of remote control for 0.5 second, turning light will stop

flashing, siren will stop alarming.

7、Trunk release (options 7)

Under any state, press the button " " of remote control for 2 seconds. Trunk will be released.

Note: It is only available for the car equipped with trunk release switch.

8、Emergency panic alarm

Press the button 1 for 2 seconds. Siren continue alarming, turning light continue flashing, indicator LED will flash

rapidly, this status will keep for 30 seconds. Press " " or " " to stop alarming.

9、ANTI-CARJACKING PROTECTION

For a higher level of personal security, the system is equipped with three programmable anti-carjacking modes:

1)、ACTIVE CARJACK

This feature provides Active Carjack protection and must be enabled before use through Alarm programming (option

10). When the Ignition is ON (running), press button 2, parking lights will flash TWICE to confirm the carjack

countdown sequence. 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning

chirps turning into a full system activation with siren/flashing light pulses for 5 min. To reset Active Carjack,

IGNITION MUST BE ON, then press Button 2 again.

2)、PASSIVE CARJACK

This feature provides Passive Carjack protection and must be enabled before use through Alarm programming (options

9 and 10). We recommend this mode should only be used in serious situations. When the Ignition is ON (vehicle is

running), and a door is opened, the Carjack countdown sequence will be initiated. 90 Seconds later, the unit will begin a

Carjack Cycle consisting of 20 seconds of per-warning chirps turning into a full system activation with siren/flashing

light pulses for 5 min. To reset Passive Carjack, IGNITION MUST BE ON AND DOORS MUST BE CLOSED, then

press the override/program button (3) times.

3)、FULL-TIME CARJACK

Use in case of extreme Carjack threat only. This feature provides full-time Carjack protection and must be enabled

before use through Alarm programming (options 9 and 10). EVERY TIME the Ignition is turned ON or a door is

opened, then closed with the Ignition ON, a Carjack countdown sequence will be initiated. 90 Seconds later, the unit

will begin a Carjack Cycle consisting of 20 seconds of pre-warming chirps turning into a full system activation with

siren/flashing light pulses for 5 min. You must reset the unit every time the IGNITION is turned on or a door is opened

and closed when the ignition is on.

TO RESET：IGNITION MUST BE ON AND DOORS MUST BE CLOSED，then press override/program button (3)

times.

NOTE: When FULL TIME CARJACK is in effect, it must be reset every time the key is turned on, door is opened,

before entering VALET mode, and before Programming options or transmitters. It is always in effect each time the

Ignition is turned on and/or a door is opened with Ignition on.

FCC Disclaimer

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

The users manual or instruction manual for an unintentional or unintentional radiator

shall caution the user that changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tsted and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

l Reorient or relocate the receiving antenna.

l Increase the separation between the equipment and receiver.

l Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

l Consult the dealer or an experienced radio/TV technician for help.