User Manual

ManualsBrandsLogicMark ManualsCell Phones3G mobile phone only call 911

User’s

QuickStart Guide

Model 30711

Mobile Personal Emergency Response System

Pendant Functions

Speaker

Emergency

Button

TEST

Button

Microphone

Manufacturer’s Disclaimers and Limited Warranty

The Manufacturer’s warranty period is one year from time of purchase.

COMMUNICATION AND RESPONSE LIMITATIONS: Purchaser acknowledges

that signals pass through communication networks wholly beyond the control

of The Manufacturer and are not maintained by The Manufacturer, and,

therefore, The Manufacturer shall not be responsible for any equipment or

communication failure which prevents transmission signals from reaching your

contact list including emergency 911 operators or damages arising therefrom.

Purchaser acknowledges that The Manufacturer provides no response to the

System’s equipment. The Manufacturer shall not be responsible for ambulance,

police or other emergency response.

TESTING AND SERVICE OF THIS EQUIPMENT: The equipment, once installed, are

in the exclusive possession and control of the Purchaser, and it is Purchaser’s sole

responsibility to test the operation of equipment and request warranty service if the

equipment is under warranty.

PURCHASER’S EXCLUSIVE REMEDY: Purchaser’s exclusive remedy for The

Manufacturer’s default hereunder is to require The Manufacturer to repair or replace,

at The Manufacturer’s option, any equipment or part of the personal emergency alert

system which is non-operational during The Manufacturer’s warranty period.

LIMITATION OF LIABILITY: This equipment is not designed or guaranteed

to prevent any loss or injury. This Limited Warranty and Disclaimer of Liability

constitutes the terms of sale and use of the equipment, and if there should arise

any liability on the part of The Manufacturer as a result of any cause whatsoever,

regardless of whether or not such loss, damage, or personal injury was caused by

or contributed to by The Manufacturer’s negligence to any degree or failure to

perform any obligation or strict products liability, such liability will be limited to an

amount paid by the Purchaser to The Manufacturer for the product, or to the sum

of $350.00, whichever is greater. For warranty information, contact Customer

Service at LogicMark, LLC.

v 5.2 Model 30711

FCC ID TYD30711

RED Charging Light

Low Battery Warning:

Flashes when battery is at less than

25% capacity

GREEN Power Light

Battery Charging:

Green Light is Blinking.

Fully charged:

Green Light is Solid.

Light is OFF when

removed from charging

base

BLUE Call In Process Light

Solid when connected to a

cellular network

PLUS

uardian

911

lert

PLUS

Guardian

911

alert

PRESS & HOLD

Test

Summary of content (4 pages)

PAGE 1
Manufacturer’s Disclaimers and Limited Warranty The Manufacturer’s warranty period is one year from time of purchase.
PAGE 2
1 Plug Base into power and charge handset GUARDIAN911 ALERTPLUS Before First Use: Fully charge handset by putting it in the charging cradle prior to use. It may take 3 to 4 hours to ensure a full charge. The Charging Light on the handset will blink Green when charging and turn solid Green when fully charged. SEE ILLUSTRATION BELOW. 2 RED Light Low battery Warning BLUE Light Call in Process System Check Press the TEST button for 4 seconds. GREEN Light 1.
PAGE 3
Things The FCC would like for you to know: 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 4
the SAR is determined at the highest certified power level, the actual SAR level of 3G mobile phone while operating can be well below the maximum value. This is because 3G mobile phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.