User's Manual

ManualsBrandsLogicMark ManualsElectronicsGuardian Alert 911

FCC Part 15

This equipment has been tested and found to comply with the requirements for a Class B digital

device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements

are intended to provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communi-

cations. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the in-

terference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two con-

ditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation. Privacy of com-

munications may not be ensured when using this telephone. To ensure safety of users, the FCC

has established criteria for the amount of radio frequency energy that can be safely absorbed by a

user or bystander according to the intended usage of the product. This product has been tested

and found to comply with the FCC criteria. Handset may be safely held against the ear of the user.

The telephone base shall be installed and used such that parts of the user’s body other than the

hands are maintained at a distance of approximately 20 cm (8 inches) or more. This Class B digital

apparatus complies with Canadian ICES-003.

FCC Part 68 and ACTA.

This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by

the Administrative Council for Terminal Attachments (ACTA). The label on the back or bottom of this

equipment contains, among other things, a product identifier in the format US: TYDW400B30911.

This identifier must be provided to your local telephone company upon request. The plug and jack

used to connect this equipment to premises wiring and the telephone network must comply with

applicable Part 68 rules and technical requirements adopted by ACTA. A compliant telephone

cord and modular plug is provided with this product. It is designed to be connected to a compat-

ible modular jack that is also compliant. An RJ11 jack should normally be used for connecting to a

single line and an RJ14 jack for two lines. See Installation Instructions in the User’s Guide.

The Ringer Equivalence Number (REN) is used to determine how many devices you may connect

to your telephone line and still have them ring when you are called. The REN for this product is

encoded as the 6th and 7th characters following the US: in the product identifier (e.g., if ## is 03,

the REN is 0.3). In most, but not all areas, the sum of all RENs should be five (5.0) or less. For more

information, please contact your local telephone company.

This equipment may not be used with Party Lines. If you have specially wired alarm dialing equip-

ment connected to your telephone line, ensure the connection of this equipment does not disable

your alarm equipment. If you have questions about what will disable alarm equipment, consult

your telephone company or a qualified installer. If this equipment is malfunctioning, it must be

unplugged from the modular jack until the problem has been corrected. Repairs to this telephone

equipment can only be made by the manufacturer or its authorized agents. For repair procedures,

follow the instructions outlined under the Limited Warranty.

FCC ID TYD3091160

v5.1

Summary of content (2 pages)

PAGE 1
FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 2
If this equipment is causing harm to the telephone network, the telephone company may temporarily discontinue your telephone service. The telephone company is required to notify you before interrupting service. If advance notice is not practical, you will be notified as soon as possible. You will be given the opportunity to correct the problem and the telephone company is required to inform you of your right to file a complaint with the FCC.