User Instructions

TX5008
F1 F2
Function uttonsb
SET Button activates the
Receiver and the keypad
function buttons
2 r s elease crews for
attery ompartmentb c
at rear.
x Alkaline batteries2 AAA
Effective working range up to a distance of
60 metres (200 feet) 50 Series
The ransmitter automatically t
transmits a signal afterSTOP
30 minutes; this de-activates
the eceiver and the ransmitter.r t
SAFETY FEATURE
!
50TX.0 E.A46
!
Instructions for Series Transmitters50 Mini
( )8 Function shown
LED
Blinks when ransmitter t
is active.
when a ransmitterON t
utton is pressed.b
while transmittingPulses
when attery is low.b
bSTOP utton switches off
the eceiver and the keypad r
function buttons
PRESS HOLD &
both (Red) STOP
and (Green)SET
for a ofMINIMUM
5 SECONDS
Then & PRESS
HOLD SET
for 5 seconds
To register Transmitters to the Receiver
1. Coding into Slot 1
1. Ensure Receiver is OFF
2. Press and hold and on Transmitter until LED goes SET STOP OFF
3. LED on Transmitter will flash once to indicate slot 1
4. Turn Receiver ON
5. Wait for green LED on Receiver to flash slowly
6. Press and hold on Transmitter until green LED on Receiver flashesSET
quickly several times
7. Check Receiver is coded correctly by pressing SET then operating any function
2. Coding into Slot 2
1. Ensure Receiver is OFF
2. Press and hold and on Transmitter until LED goes SET STOP OFF
3. LED on Transmitter will flash once to indicate slot 1
4. Press to select slot 2 – the LED on Transmitter will flash twiceSET
5. Turn Receiver ON
6. Wait for green LED on Receiver to flash slowly
7. Press and hold on Transmitter until green LED on Receiver flashesSET
quickly several times
8 n. Check Receiver is coded correctly by pressing SET then operating any functio
If you have any problems please phone either your local Distributor or Lodar directly:-
U (0) +1-K [phone]. US 877- 257-1581.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.