User Instructions

To register Transmitters to the Receiver.
Switch OFF or DISCONNECT the power to the
Receiver and briefly PRESS the STOP button
on one or both Transmitter(s).
Switch ON or Reconnect the power to the Receiver.
This opens a 20 second registration window and is indicated through
flashing of the FAULT LED on the Receiver PCB.
Immediately PRESS and HOLD both the Transmitters SET
and F1 Buttons. Continue to hold BOTH BUTTONS
for a MINIMUM of 5 seconds during this 20 second window.
When the Transmitter is Registered the Fault LED on the Receiver will be illuminated for 3 seconds.
Once completed, the buttons can then be released.
TO REGISTER TWO TRANSMITTERS:
When the fault light starts to flash again, and F1 immediately PRESS and HOLD both the Transmitter SET
Buttons of the second Transmitter. Continue to hold BOTH BUTTONS for a MINIMUM of 5 seconds or until
the SET LED comes on. Both your Transmitters will now operate the Receiver.
PRIORITY.
Only one Transmitter can be active at any time. For the second Transmitter to work you have to turn off the
first Transmitter. Once the second Transmitter is being used then that has priority and it has to be turned off
before the first Transmitter can work again.
If you have any problems please phone either your local Distributor or Lodar directly:-
UK [phone]. US [phone].
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
F1 F2
Function buttons
SET Button activates the
Receiver and the keypad
function buttons
4 release screws for
battery compartment
at rear.
4 x AAA Alkaline batteries
Effective working range up to a distance of
60 metres (200 feet) 92 Series
The transmitter automatically
transmits a STOP signal after
30 minutes; this de-activates
the receiver and the transmitter.
SAFETY FEATURE
!
92TX.06E.A4
!
PRESS & HOLD
both SET and F1
for a MINIMUM of
5 SECONDS
Instructions for 92 Series IP Transmitters
(16 Function shown)
www.lodar.com
STOP button switches off
the receiver and the keypad
function buttons
LED
Blinks when transmitter
is active.
ON when a transmitter
button is pressed.
Pulses while transmitting
when battery is low.