Installation Instructions

Tools Typically Required:
Utility knife, caulking gun, tool to puncture cartridge seal, plant mister bottle containing water.
Safety Precautions:
Wear gloves to avoid skin contact. Cured adhesive on bare skin will not come off immediately with washing and may cause skin to
darken. Cured adhesive and discoloration will come off of skin in about 3 days.
Preparation:
Use above 41°F (5°C). For easier application, ensure the product temperature is 59°F (15°C) or higher. Surfaces must be clean and
free of frost, standing water, grease, dust and other contaminants. Pre-fit all materials and protect finished surfaces. Cut nozzle at a
45° angle to required opening, usually ¼ inch or wider. Puncture the inner seal of the cartridge. The foil seal must be completely
opened using a tool of similar size as the opening. Be very careful not to allow PL Premium Fast Grab to cure on a finished surface.
Application:
Apply adhesive to one surface of the material being bonded. Press the surfaces firmly together. Materials may be repositioned
within 20 minutes after applying the adhesive. If bonding two non-porous surfaces (such as foam, metal and fiberglass) or under
very dry conditions (less than 30% relative humidity), add water in the form of a very light or atomized spray from a plant mister
bottle to the extruded adhesive. The repositioning time will then be reduced to less than 15 minutes. Use mechanical support for 24
hours while the adhesive cures. Cure time is dependent upon temperature, humidity, porosity of substrate and amount of adhesive
used. Low temperature and humidity will slow cure time. When bonding EPS and XPS foam insulation, avoid cure and surface
temperatures above 90°F (32°C).
Clean-up:
Clean tools and adhesive residue immediately with mineral spirits. Loctite® PL® Premium Fast Grab must be removed mechanically
once cured.