User's Manual

ManualsBrandsLOCKLY ManualsElectronicsWireless Exit Button

PLA3542Q/PGA387 STM000,REV.B,160x80mm 80G

, ROHS2.0,REACH,POPs,PAHS,PROP65

ERP PLA3542Q-GL-SMT00030A-V1 ERP P/N:

REV 0.1

is based on bidirectional RF433.92MHz

and Lockly 2.0 proprietary encryption, providing communication

reliability, stability, and better security. It operates with 2 x CR2032

batteries which last up to 12 months. It is quick and very easy to install

and can be mounted anywhere. When using for the first time, please

refer to the following steps to install and pair.

É×ÎÛÔÛÍÍ ÛÈ×Ì ÞËÌÌÑÒ øÐÙßíèé÷

Installation & User Manual

remove the backplate

cover.

2 x CR2032

Batteries

3 4

1. Press buckle button to 2.

pairing within 3 minutes after pressing

the button or it will exit the pairing mode

if no action is taken. If you want to

attempt pairing again, please take out

and reinsert the batteries, then short

press the button to start pairing. Refer to

the manual of the smart lock on how to

enter pairing mode and ensure pairing is

successful before mounting to your

desired location.

backplate and mount on desired

location (near the exit door). You can

also use screws to secure the backplate.

Press the button.

WARNING: This product can expose you to chemicals including Lead,

which is known to the State of California to cause cancer. For more

information go to www.P65Warnings.ca.gov.

FCC Warning:

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the

party responsible for compliance could void the user's authority to operate the

equipment.

FCC Radiation Exposure Statement

The Secure Link Wi-Fi Hub complies with FCC radiation exposure limits set forth

for an uncontrolled environment. It should be installed and operated with

minimum distance 20cm between the radiator & your body.

IC WARNING

This device contains licence-exempt transmitter(s) that comply with

Innovation,Science and Economic Development Canada’s licence-exempt

RSS(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may

cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil

est conforme aux CNR d’Innovation, Sciences et Développement

économique Canada applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes:

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si

le brouillage est susceptible d’en compromettre le fonctionnement.

IC Radiation Exposure Statement

This equipment meets the exemption from the routine evaluation limits in

section 2.5 of RSS-102. It should be installed and operated with a minimum

distance of 20cm between the radiator and any part of your body.

Cet équipement est conforme à l'exemption des limites d'évaluation

habituelle de la section 2.5 de la norme RSS-102. Il doit être installé et utilisé à

une distance minimale de 20 cm entre le radiateur et toute partie de votre

corps.